Wraps by car

MG MGA wrap

The MG MGA wrap page covers the single-generation classic sports car produced from 1955 to 1962. A full vinyl wrap of the newest body takes about 38 ft (11.5 m) for the convertible to 43 ft (13 m) for the coupe using 60-inch (1.52 m) cast film. This page explains the two body styles and the film amounts each one needs.

1generations13 mof film for a full wrap

MG MGA, first generation, factory photo
MG MGA, first generation. Factory color shown.

MG MGA wrap colors and ideas

  • MG MGA black wrap
  • MG MGA white wrap
  • MG MGA gray wrap
  • MG MGA silver wrap
  • MG MGA red wrap
  • MG MGA blue wrap
  • MG MGA green wrap
  • MG MGA yellow wrap
  • MG MGA orange wrap
  • MG MGA purple wrap
  • MG MGA pink wrap
  • MG MGA teal wrap
  • MG MGA brown wrap
  • MG MGA gold wrap
  • MG MGA chrome wrap
  • MG MGA color shift wrap
  • MG MGA carbon fiber wrap
  • MG MGA camo and patterned wrap

How much vinyl to wrap an MG MGA

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1955–1962convertible, coupe (2 doors)156.0 in (3,962 mm)about 38 ft (11.5 m) for the convertible to 43 ft (13 m) for the coupe, 60-inch (1.52 m) cast film; chrome or patterned film: up to about 48 ft (14.5 m)

MG MGA wrap cost factors

MG MGA wrap cost depends on the film type, the body style, and the amount of surface preparation. The convertible needs about 38 ft (11.5 m) of film, while the coupe needs up to 43 ft (13 m), so a coupe wrap uses more material. Chrome delete or patterned film adds up to about 48 ft (14.5 m) and increases the total. The condition of the original paint also affects the labor time for surface correction before the wrap.

  • Film for a full wrap: about 38 ft (11.5 m) for the convertible to 43 ft (13 m) for the coupe, 60-inch (1.52 m) cast film; chrome or patterned film: up to about 48 ft (14.5 m).
  • Body: convertible, coupe (2 doors).
  • Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.
  • Two long side doors: each door is one large piece of film.

MG MGA wraps by generation

Swipe sideways. Tap a card for the full description.

MG MGA, first generation, factory photo
Factory color shown

1955–1962 MG MGA convertible, coupe (first generation)

1955–1962convertible, coupe (2 doors)156.0 in (3,962 mm)

The first generation MG MGA has an open top on the convertible, and the fabric top is not wrapped. The film ends where the top begins, leaving a clean line at the body edge. A folding hard top is wrapped as separate panels, so you can choose a contrasting color for it.

Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

Two long side doors: each door is one large piece of film.

Film: about 38 ft (11.5 m) for the convertible to 43 ft (13 m) for the coupe, 60-inch (1.52 m) cast film; chrome or patterned film: up to about 48 ft (14.5 m).

Roof, hood, chrome delete and PPF on an MG MGA

MG MGA chrome delete covers the window trim and badges with black film, while a partial wrap can include the roof, hood, or mirror caps. The hood is a single large panel that suits a contrasting color change. Paint protection film (PPF) is applied as a clear film on the front end to guard against stone chips.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping an MG MGA: body, cut-outs and film

An MG MGA vinyl wrap follows the small two-door body of this classic roadster. The car is 156.0 in (3,962 mm) long, so a full color change uses less film than a modern four-door sedan. The convertible and the coupe share the same length, but the coupe adds a fixed roof that increases the wrapped area.

MG MGA wrap ideas start with the two long side doors, each covered by one large piece of film. The fabric top on a convertible is not wrapped, and the film ends where the top begins. A folding hard top is wrapped as panels of its own, while a coupe roof is part of the main body wrap.

How much vinyl to wrap an MG MGA depends on the body style you own. The convertible needs about 38 ft (11.5 m) of 60-inch (1.52 m) cast film for a full wrap. The coupe takes up to 43 ft (13 m) because of its fixed roof and rear window surround. Buy extra film if you plan chrome or patterned accents, as those add up to about 48 ft (14.5 m).

Questions about wrapping an MG MGA

How much vinyl does it take to wrap an MG MGA?

How much vinyl does it take to wrap an MG MGA? A full wrap of the newest body takes about 38 ft (11.5 m) for the convertible to 43 ft (13 m) for the coupe using 60-inch (1.52 m) cast film; chrome or patterned film adds up to about 48 ft (14.5 m).

Is the top of an MG MGA wrapped?

Is the top of an MG MGA wrapped? No, the fabric top of a convertible is not wrapped, and the film ends where the top begins; a folding hard top is wrapped as panels of its own.

Which MG MGA body takes more film?

Which MG MGA body takes more film? The coupe takes more film than the convertible, needing up to 43 ft (13 m) compared to about 38 ft (11.5 m) because of the fixed roof.

Can I wrap only the hood or the roof of an MG MGA?

Can I wrap only the hood or the roof of an MG MGA? Yes, a partial wrap covers the roof, hood, or mirror caps, and paint protection film (PPF) is applied as clear film on the front end.