Wraps by car

MG MGC wrap

The MG MGC wrap page covers this 1967–1969 coupe, its single generation, and the film a full wrap of the newest body takes. A full wrap of the MG MGC uses about 39 ft (12 m) of 60-inch (1.52 m) cast film. If you choose chrome or patterned film, plan for about 48 ft (14.5 m). This page gives body details and answers on partial jobs, chrome delete, and paint protection film.

1generations12 mof film for a full wrap

MG MGC, first generation, factory photo
MG MGC, first generation. Factory color shown.

MG MGC wrap colors and ideas

  • MG MGC black wrap
  • MG MGC white wrap
  • MG MGC gray wrap
  • MG MGC silver wrap
  • MG MGC red wrap
  • MG MGC blue wrap
  • MG MGC green wrap
  • MG MGC yellow wrap
  • MG MGC orange wrap
  • MG MGC purple wrap
  • MG MGC pink wrap
  • MG MGC teal wrap
  • MG MGC brown wrap
  • MG MGC gold wrap
  • MG MGC chrome wrap
  • MG MGC color shift wrap
  • MG MGC carbon fiber wrap
  • MG MGC camo and patterned wrap

How much vinyl to wrap an MG MGC

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1967–1969coupe (2 doors)153.0 in (3,886 mm)about 39 ft (12 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 48 ft (14.5 m)

MG MGC wrap cost factors

MG MGC wrap cost depends on the film type, the number of panels, and the work the body needs. A full color change wrap takes about 39 ft (12 m) of 60-inch (1.52 m) film, while chrome or patterned film takes about 48 ft (14.5 m). The two long doors add labor because each one is a single large piece that must be aligned. Paint condition on a 1967–1969 car also matters, since old paint may need correction before the wrap.

  • Film for a full wrap: about 39 ft (12 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 48 ft (14.5 m).
  • Body: coupe (2 doors).
  • Two long side doors: each door is one large piece of film.

MG MGC wraps by generation

Swipe sideways. Tap a card for the full description.

MG MGC, first generation, factory photo
Factory color shown

1967–1969 MG MGC coupe (first generation)

1967–1969coupe (2 doors)153.0 in (3,886 mm)

The first generation MG MGC, built from 1967 to 1969, is a two-door coupe 153.0 in (3,886 mm) long. Before a full wrap, check the paint age: on a car of these years panels may be original or repainted. A test spot comes before a full wrap to see how the film adheres to the old finish. The installer can then decide if any panel needs paint correction first.

Two long side doors: each door is one large piece of film.

Film: about 39 ft (12 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 48 ft (14.5 m).

Roof, hood, chrome delete and PPF on an MG MGC

For a partial wrap on the MG MGC, you can cover the roof, hood, or mirror caps. A chrome delete covers the window trim and badges with black film. Paint protection film (PPF) is clear film applied to the front end to guard against stone chips. These smaller jobs use less film than a full wrap and can be done without covering the doors.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping an MG MGC: body, cut-outs and film

The MG MGC vinyl wrap has to handle one body style: a two-door coupe with long side doors. Each door is one large piece of film, so the installer can keep the pattern aligned across the panel. The car is 153.0 in (3,886 mm) long, and a wrap covers the full body from nose to tail. That length means the film is cut into manageable sections that meet at the panel edges.

MG MGC wrap ideas start with the two long side doors, which need one large piece of film each. The installer must remove or mask door handles, mirrors, and badges before the film goes on. The coupe's fixed roof can be wrapped as a separate panel for a two-tone look. All edges are trimmed and tucked so the film stays tight around the door jambs.

When you count how much vinyl to wrap an MG MGC, the single generation makes the math simple. The 1967–1969 coupe has the same body size and panel layout in every production year. A full wrap uses about 39 ft (12 m) of 60-inch (1.52 m) cast film, and chrome or patterned film uses about 48 ft (14.5 m). There are no later bodies with different lengths or door shapes to change the film estimate.

Questions about wrapping an MG MGC

How much vinyl does it take to wrap an MG MGC?

It takes about 39 ft (12 m) of 60-inch (1.52 m) cast film to wrap an MG MGC. If you want chrome or patterned film, the amount goes up to about 48 ft (14.5 m). These figures come from the film estimate for the newest body, which is the only body this car was built with.

Can I wrap only the hood or the roof of an MG MGC?

Yes, you can wrap only the hood or the roof of an MG MGC. A partial wrap on this car can also cover the mirror caps. Those panels are separate from the doors and can be done as small jobs. A chrome delete on the window trim and badges is another partial option.

Is an MG MGC hard to wrap?

The MG MGC is not the hardest car to wrap, but its two long side doors add work. Each door is one large piece of film, so the installer must handle a big sheet without creases. The car's 153.0 in (3,886 mm) length is moderate for a coupe. The fixed roof can also take extra time because it is a large, curved panel.

How many generations of the MG MGC does this page cover?

This page covers one generation of the MG MGC. The car was produced from 1967 to 1969 as a two-door coupe. There are no other body styles or later generations in the catalog.