Wraps by car

MG ZR wrap

An MG ZR wrap covers the first-generation compact hatchback made from 2001 to 2005. A full vinyl wrap of this car takes about 46 ft (14 m) of 60-inch (1.52 m) cast film. The three- or five-door body fits one design with no other generation to consider.

1generations14 mof film for a full wrap

MG ZR, first generation, factory photo
MG ZR, first generation. Factory color shown.

MG ZR wrap colors and ideas

  • MG ZR black wrap
  • MG ZR white wrap
  • MG ZR gray wrap
  • MG ZR silver wrap
  • MG ZR red wrap
  • MG ZR blue wrap
  • MG ZR green wrap
  • MG ZR yellow wrap
  • MG ZR orange wrap
  • MG ZR purple wrap
  • MG ZR pink wrap
  • MG ZR teal wrap
  • MG ZR brown wrap
  • MG ZR gold wrap
  • MG ZR chrome wrap
  • MG ZR color shift wrap
  • MG ZR carbon fiber wrap
  • MG ZR camo and patterned wrap

How much vinyl to wrap an MG ZR

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
2001–2005hatchback (3 or 5 doors)157.9 in (4,011 mm)about 46 ft (14 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 57 ft (17.5 m)

MG ZR wrap cost factors

An MG ZR wrap cost depends on the film and the areas covered. A full color change on this 157.9 in (4,011 mm) hatchback uses about 46 ft (14 m) of 60-inch (1.52 m) cast film, while patterned film takes about 57 ft (17.5 m). The installer also charges for time spent on the tailgate and any repair of old paint.

  • Film for a full wrap: about 46 ft (14 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 57 ft (17.5 m).
  • Body: hatchback (3 or 5 doors).
  • A tailgate with the rear glass in it: the film ends at the edge of the glass.

MG ZR wraps by generation

Swipe sideways. Tap a card for the full description.

MG ZR, first generation, factory photo
Factory color shown

2001–2005 MG ZR hatchback (first generation)

2001–2005hatchback (3 or 5 doors)157.9 in (4,011 mm)

The first generation MG ZR was made from 2001 to 2005. On a car of these years some panels may still have original paint and others may be repainted. A test spot on each panel shows whether the vinyl will stick well before a full wrap.

A tailgate with the rear glass in it: the film ends at the edge of the glass.

Film: about 46 ft (14 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 57 ft (17.5 m).

Roof, hood, chrome delete and PPF on an MG ZR

An MG ZR chrome delete covers the window trim and badges with black film. A partial wrap on this car often includes the roof, hood or mirror caps as single areas. Paint protection film (PPF) can be applied as clear film on the front end to guard against stone chips.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film on the front end, also over a wrap.

Wrapping an MG ZR: body, cut-outs and film

An MG ZR vinyl wrap follows the size of a 157.9 in (4,011 mm) long compact hatchback. The three- and five-door styles share the same roof, hood and rear quarters, so film use stays close from one body to the next. A wrap on either door count needs about 46 ft (14 m) of 60-inch (1.52 m) film for full color change.

MG ZR wrap ideas start with the tailgate, where the rear glass sits inside the panel. The vinyl ends at the edge of that glass, so the installer cuts a clean line around the window. The roof and hood also give large, flat areas for a contrast color or a stripe.

How much vinyl to wrap an MG ZR stays the same across the years of this generation. The body shape did not change from 2001 to 2005, so a full wrap takes about 46 ft (14 m) of 60-inch (1.52 m) cast film. A chrome or patterned film needs about 57 ft (17.5 m) because the pattern must be matched.

Questions about wrapping an MG ZR

How much vinyl does it take to wrap an MG ZR?

It takes about 46 ft (14 m) of 60-inch (1.52 m) cast film to wrap an MG ZR fully. That figure is for a color change wrap on the three- or five-door hatchback body. A chrome or patterned film needs about 57 ft (17.5 m) to match the pattern.

Can I wrap only the hood or the roof of an MG ZR?

Yes, you can wrap only the hood or the roof of an MG ZR. A partial wrap on this car often covers the roof, hood or mirror caps as single areas. The installer measures the panel and cuts the film to fit without wrapping the whole car.

Is an MG ZR hard to wrap?

An MG ZR is not hard to wrap, but the tailgate adds work because the rear glass sits in the panel. The film must end at the edge of the glass, so the installer spends extra time cutting a clean line around the window. The compact size of 157.9 in (4,011 mm) keeps the rest of the job straightforward.

How many generations of the MG ZR does this page cover?

This page covers one generation of the MG ZR, made from 2001 to 2005. The catalog lists only the first generation, a hatchback with three or five doors. All wrap figures on this page refer to that generation.