Wraps by car

TVR S-Series wrap

The TVR S-Series wrap page covers the first generation convertible from 1986 to 1996. A full wrap of this car takes about 38 ft (11.5 m) of 60-inch (1.52 m) cast vinyl wrap. The S-Series is a compact sports car with a body length of 155.8 in (3,958 mm).

1generations11.5 mof film for a full wrap

TVR S-Series, first generation, factory photo
TVR S-Series, first generation. Factory color shown.

TVR S-Series wrap colors and ideas

  • S-Series black wrap
  • S-Series white wrap
  • S-Series gray wrap
  • S-Series silver wrap
  • S-Series red wrap
  • S-Series blue wrap
  • S-Series green wrap
  • S-Series yellow wrap
  • S-Series orange wrap
  • S-Series purple wrap
  • S-Series pink wrap
  • S-Series teal wrap
  • S-Series brown wrap
  • S-Series gold wrap
  • S-Series chrome wrap
  • S-Series color shift wrap
  • S-Series carbon fiber wrap
  • S-Series camo and patterned wrap

How much vinyl to wrap a TVR S-Series

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1986–1996convertible (2 doors)155.8 in (3,958 mm)about 38 ft (11.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 48 ft (14.5 m)

S-Series wrap cost factors

S-Series wrap cost depends on the film, the finish, and how much of the 155.8 in (3,958 mm) body is covered. A full wrap uses about 38 ft (11.5 m) of 60-inch (1.52 m) cast film, while a chrome or patterned film needs about 48 ft (14.5 m). The short body keeps the job smaller than on a long convertible.

  • Film for a full wrap: about 38 ft (11.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 48 ft (14.5 m).
  • Body: convertible (2 doors).
  • Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

S-Series wraps by generation

Swipe sideways. Tap a card for the full description.

TVR S-Series, first generation, factory photo
Factory color shown

1986–1996 S-Series convertible (first generation)

1986–1996convertible (2 doors)155.8 in (3,958 mm)

The first generation TVR S-Series has a fabric top that is not wrapped. The vinyl film ends at the edge of the top, following the body line at the beltline. If a folding hard top is fitted, it is wrapped as its own panels.

Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

Film: about 38 ft (11.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 48 ft (14.5 m).

Roof, hood, chrome delete and PPF on an S-Series

Partial wrap on a TVR S-Series covers the hood, mirror caps, or rear deck. You can also have a chrome delete on the window trim and badges with black film. Paint protection film (PPF) is an option as a clear film on the front end.

  • Partial wrap: hood, mirror caps, rear deck.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a TVR S-Series: body, cut-outs and film

A TVR S-Series vinyl wrap follows the lines of a two-door convertible. The body is 155.8 in (3,958 mm) long, which is short for a sports car, so film runs are short and positioning is straightforward. The wrap film ends where the fabric top begins, so the top itself is not covered.

S-Series wrap ideas start with the convertible body. The folding top is not wrapped, and the film ends at its edge. Door handles, badges, and window trim come off or are cut around for a clean finish.

How much vinyl to wrap an S-Series depends on the film type. A single-generation car from 1986 to 1996 keeps the same body, so the estimate of about 38 ft (11.5 m) of 60-inch (1.52 m) cast film applies throughout. If you choose a chrome or patterned film, allow about 48 ft (14.5 m) for matching.

Questions about wrapping a TVR S-Series

How much vinyl does it take to wrap a TVR S-Series?

It takes about 38 ft (11.5 m) of 60-inch (1.52 m) cast film to wrap a TVR S-Series. For chrome or patterned film, plan on about 48 ft (14.5 m). These numbers cover the full body of the 1986–1996 convertible.

Is the top of an S-Series wrapped?

No, the top of an S-Series is not wrapped. The fabric top is left as it is, and the vinyl film ends where the top begins.

Can I wrap only the hood or the roof of an S-Series?

Yes, you can wrap only the hood or the rear deck of an S-Series. Partial wrap options also include the mirror caps. A chrome delete on the window trim and badges is another smaller job.

Is an S-Series hard to wrap?

An S-Series is not especially difficult to wrap, but the convertible top adds work at the edges. The wrap film must be cut cleanly where the fabric top begins. The short body of 155.8 in (3,958 mm) keeps panel sizes manageable.