Wraps by car

Mazda Efini MS-8 wrap

This page is a wrap guide for the Mazda Efini MS-8, a full-size sedan produced from 1992 to 1998. The catalog covers one generation of this four-door model. A full wrap of the body takes about 52 ft (16 m) of 60-inch (1.52 m) cast film.

1generations16 mof film for a full wrap

Mazda Efini MS-8, first generation, factory photo
Mazda Efini MS-8, first generation. Factory color shown.

Mazda Efini MS-8 wrap colors and ideas

  • Efini MS-8 black wrap
  • Efini MS-8 white wrap
  • Efini MS-8 gray wrap
  • Efini MS-8 silver wrap
  • Efini MS-8 red wrap
  • Efini MS-8 blue wrap
  • Efini MS-8 green wrap
  • Efini MS-8 yellow wrap
  • Efini MS-8 orange wrap
  • Efini MS-8 purple wrap
  • Efini MS-8 pink wrap
  • Efini MS-8 teal wrap
  • Efini MS-8 brown wrap
  • Efini MS-8 gold wrap
  • Efini MS-8 chrome wrap
  • Efini MS-8 color shift wrap
  • Efini MS-8 carbon fiber wrap
  • Efini MS-8 camo and patterned wrap

How much vinyl to wrap a Mazda Efini MS-8

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1992–1998sedan (4 doors)184.8 in (4,695 mm)about 52 ft (16 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 64 ft (19.5 m)

Efini MS-8 wrap cost factors

The Efini MS-8 wrap cost depends on the size of the car, the amount of film needed and the labor for its body. This sedan needs about 52 ft (16 m) of wrap film for a full color change. The single four-door body style means there are no extra doors or large roof variations to price. More complex film like chrome or patterns raises the cost because it uses about 64 ft (19.5 m).

  • Film for a full wrap: about 52 ft (16 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 64 ft (19.5 m).
  • Body: sedan (4 doors).

Efini MS-8 wraps by generation

Swipe sideways. Tap a card for the full description.

Mazda Efini MS-8, first generation, factory photo
Factory color shown

1992–1998 Efini MS-8 sedan (first generation)

1992–1998sedan (4 doors)184.8 in (4,695 mm)

The first generation Mazda Efini MS-8 was built from 1992 to 1998 as a four-door sedan. This body shares its length of 184.8 in (4,695 mm) and full-size class across all years. Paint age on a car of these years may be original or repainted, and a test spot comes before a full wrap. Wrapping an older surface needs careful cleaning and adhesion checks on every panel.

Film: about 52 ft (16 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 64 ft (19.5 m).

Roof, hood, chrome delete and PPF on an Efini MS-8

You can choose a partial wrap on the Efini MS-8 for the roof, hood or mirror caps instead of a full wrap. A chrome delete covers the window trim and badges with black film for a different look. Paint protection film (PPF) is clear film applied to the front end to guard against stone chips. These jobs use less film and focus on the areas with the most wear.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Mazda Efini MS-8: body, cut-outs and film

The Mazda Efini MS-8 vinyl wrap is planned around a single sedan body style with four doors. The car measures 184.8 in (4,695 mm) in length, which is a typical size for a full-size sedan. This length means the roof, hood and trunk are large panels that need film in 60-inch (1.52 m) width. A wrap installer works section by section across the long flat sides.

Efini MS-8 wrap ideas start with the trim and badges that complicate a clean install. The door handles, mirrors, window trim and badges need to be removed or cut out carefully. The front and rear bumpers have complex curves that take more time than flat panels. Plan for extra film around the door edges and wheel arches.

To know how much vinyl to wrap an Efini MS-8 you compare this car's size with other sedans. There is only one generation, so the estimate stays the same for all years. The full-size body uses about 52 ft (16 m) of standard cast film for a complete color change wrap. If you choose chrome or patterned film, plan for about 64 ft (19.5 m) due to matching and waste.

Questions about wrapping a Mazda Efini MS-8

How much vinyl does it take to wrap a Mazda Efini MS-8?

About 52 ft (16 m) of 60-inch (1.52 m) cast film is needed to wrap a Mazda Efini MS-8. This figure comes from the single body size of this full-size sedan. For chrome or patterned film, the estimate is about 64 ft (19.5 m).

Can I wrap only the hood or the roof of an Efini MS-8?

Yes, you can wrap only the hood or the roof of an Efini MS-8. Partial wrap jobs include the roof, hood and mirror caps. These smaller areas need less film and can be done without covering the whole car.

Is an Efini MS-8 hard to wrap?

An Efini MS-8 is not unusually hard to wrap, but its size and trim add work. The full-size sedan body has long panels and four doors that require careful film handling. The door handles, mirrors, window trim and badges need removal or precise cut-outs.

How many generations of the Efini MS-8 does this page cover?

This page covers one generation of the Mazda Efini MS-8. The model was made from 1992 to 1998 in a single generation. All years share the same body style and dimensions.