Wraps by car

Mazda Etude wrap

The Mazda Etude wrap page covers the single first generation built from 1987 to 1989, a compact three-door hatchback known internally as BF. A full color change on this body takes about 48 ft (14.5 m) of 60-inch (1.52 m) cast vinyl wrap. If you choose a chrome or patterned film, plan for about 59 ft (18 m) to allow for matching the pattern at the seams.

1generations14.5 mof film for a full wrap

Mazda Etude, first generation, factory photo
Mazda Etude, first generation. Factory color shown.

Mazda Etude wrap colors and ideas

  • Etude black wrap
  • Etude white wrap
  • Etude gray wrap
  • Etude silver wrap
  • Etude red wrap
  • Etude blue wrap
  • Etude green wrap
  • Etude yellow wrap
  • Etude orange wrap
  • Etude purple wrap
  • Etude pink wrap
  • Etude teal wrap
  • Etude brown wrap
  • Etude gold wrap
  • Etude chrome wrap
  • Etude color shift wrap
  • Etude carbon fiber wrap
  • Etude camo and patterned wrap

How much vinyl to wrap a Mazda Etude

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1987–1989hatchback (3 doors)161.6 in (4,105 mm)about 48 ft (14.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 59 ft (18 m)

Etude wrap cost factors

Etude wrap cost depends on the condition of the 1987–1989 panels, because paint that is original or resprayed needs testing before the film goes on. The size of the job matters: a full vinyl wrap uses about 48 ft (14.5 m) of 60-inch (1.52 m) film, while chrome or patterned film goes up to about 59 ft (18 m). A partial wrap of the roof and hood uses clearly less material and less labor than covering the whole car.

  • Film for a full wrap: about 48 ft (14.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 59 ft (18 m).
  • Body: hatchback (3 doors).
  • A tailgate with the rear glass in it: the film ends at the edge of the glass.
  • Two long side doors: each door is one large piece of film.

Etude wraps by generation

Swipe sideways. Tap a card for the full description.

Mazda Etude, first generation, factory photo
Factory color shown

1987–1989 Etude hatchback (first generation)

1987–1989hatchback (3 doors)161.6 in (4,105 mm)

The first generation Mazda Etude from 1987 to 1989 is a compact three-door hatchback with body code BF. On a car of these years the panels may be original or resprayed, and the installer performs a test spot before the full wrap to check paint adhesion. The rear tailgate has the glass inside it, so the film edge follows the glass line exactly. The two side doors are long single pieces of film that take time to position without wrinkles.

A tailgate with the rear glass in it: the film ends at the edge of the glass.

Two long side doors: each door is one large piece of film.

Film: about 48 ft (14.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 59 ft (18 m).

Roof, hood, chrome delete and PPF on an Etude

Partial wrap options for the Mazda Etude include the roof, hood and mirror caps in a color change film. Etude chrome delete covers the window trim and badges with black film over the bright parts. Paint protection film (PPF) is a clear film applied to the front end to guard the hood, fenders and bumper from stone chips. These smaller jobs let an owner change the look of the 1987–1989 hatchback without a full wrap.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Mazda Etude: body, cut-outs and film

The Mazda Etude vinyl wrap uses the short 161.6 in (4,105 mm) body to keep material use lower than on longer cars. The three-door hatchback has only two long side doors, so the installer manages fewer panel seams overall. The tailgate carries the rear glass inside it, which means the film stops at the glass edge instead of wrapping a separate metal frame. Because the roof is short, one piece of 60-inch film can often cover it without a center seam.

Etude wrap ideas should plan for the tailgate with the rear glass in it, where the film ends at the edge of the glass. Each of the two long side doors is cut as one large piece of film, so the installer needs a clean, flat surface and good access around the door edges. The mirrors come off for a clean wrap, and the badges are removed for a chrome delete before being reinstalled or replaced.

How much vinyl to wrap an Etude stays the same because the catalog holds only the 1987–1989 first generation, body code BF. There is no second body style or later generation to compare, so the film estimate does not change across production years. The only adjustment an installer makes is for the condition of the paint, not for a different body size.

Questions about wrapping a Mazda Etude

How much vinyl does it take to wrap a Mazda Etude?

It takes about 48 ft (14.5 m) of 60-inch (1.52 m) cast film to wrap a Mazda Etude in a standard color change. If you choose chrome or patterned film, the estimate rises to about 59 ft (18 m) because the installer has to align the pattern at the seams.

Can I wrap only the hood or the roof of an Etude?

Yes, you can wrap only the hood or the roof of an Etude. The partial wrap options for this car are the roof, hood and mirror caps, so a single panel like the hood is a common smaller job. The film for the hood is cut from a piece of 60-inch (1.52 m) material and trimmed to the panel edges.

Is an Etude hard to wrap?

An Etude is not hard to wrap for an installer who handles the tailgate glass and the long doors. The tailgate has the rear glass inside it, so the film must end exactly at the edge of the glass without lifting. Each of the two long side doors is one large piece of film, which requires careful squeegeeing to avoid wrinkles. The short 161.6 in (4,105 mm) body keeps the roof and quarters small, so there are no complex curves like those on a modern crossover.

How many generations of the Etude does this page cover?

This page covers one generation of the Mazda Etude, the first and only generation built from 1987 to 1989. The catalog has a single body style for this model, the three-door hatchback with body code BF.