Wraps by car

Mitsuoka Like wrap

The Mitsuoka Like wrap page covers the first generation of this small electric hatchback. The Like was produced from 2010 to 2012 as a five-door hatchback. A full wrap of this body takes about 46 ft (14 m) of 60-inch (1.52 m) cast vinyl wrap. With chrome or patterned film, plan for about 54 ft (16.5 m).

1generations14 mof film for a full wrap

Mitsuoka Like, first generation, factory photo
Mitsuoka Like, first generation. Factory color shown.

Mitsuoka Like wrap colors and ideas

  • Like black wrap
  • Like white wrap
  • Like gray wrap
  • Like silver wrap
  • Like red wrap
  • Like blue wrap
  • Like green wrap
  • Like yellow wrap
  • Like orange wrap
  • Like purple wrap
  • Like pink wrap
  • Like teal wrap
  • Like brown wrap
  • Like gold wrap
  • Like chrome wrap
  • Like color shift wrap
  • Like carbon fiber wrap
  • Like camo and patterned wrap

How much vinyl to wrap a Mitsuoka Like

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
2010–2012hatchback (5 doors)140.6 in (3,570 mm)about 46 ft (14 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 54 ft (16.5 m)

Like wrap cost factors

A Like wrap cost depends on the size of the job and the film used. The car is 140.6 in (3,570 mm) and needs about 46 ft (14 m) of standard cast film. A partial wrap uses less film and less labor than the full vehicle. Film finish, preparation and the condition of the paint also change the final cost.

  • Film for a full wrap: about 46 ft (14 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 54 ft (16.5 m).
  • Body: hatchback (5 doors).
  • A tailgate with the rear glass in it: the film ends at the edge of the glass.
  • Electric car: the charge port door is wrapped as a small piece of its own.

Like wraps by generation

Swipe sideways. Tap a card for the full description.

Mitsuoka Like, first generation, factory photo
Factory color shown

2010–2012 Like hatchback (first generation)

2010–2012hatchback (5 doors)140.6 in (3,570 mm)

The first generation Mitsuoka Like was built from 2010 to 2012. A car of these years may have original or repainted panels, so a test spot comes before a full wrap. The wrap shop checks paint adhesion on a small area before the whole car is covered. That step prevents peeling film on older paint.

A tailgate with the rear glass in it: the film ends at the edge of the glass.

Electric car: the charge port door is wrapped as a small piece of its own.

Film: about 46 ft (14 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 54 ft (16.5 m).

Roof, hood, chrome delete and PPF on a Like

A partial wrap on a Mitsuoka Like can cover the roof, hood or mirror caps alone. A Like chrome delete covers the window trim and badges with black film. Paint protection film (PPF) is a clear film applied to the front end. Each small job uses its own film and takes less material than a full wrap.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film on the front end, also over a wrap.

Wrapping a Mitsuoka Like: body, cut-outs and film

A Mitsuoka Like vinyl wrap is sized for one compact five-door shell. The car is 140.6 in (3,570 mm) long, so a full wrap needs less film than a mid-size vehicle. Every door, the roof and both bumpers are wrapped as separate panels. The short body means fewer seams and lower material use than longer cars.

Like wrap ideas start from a tailgate with the rear glass in it. The film ends at the edge of the glass, so this panel is cut precisely around the window. The charge port door is wrapped as a small separate piece to keep the port working. Door handles, badges and lights are removed or masked before the vinyl goes on.

To find how much vinyl to wrap a Like, measure the exact car before ordering. This page covers only the first generation, produced from 2010 to 2012 as one body style. The estimate of 46 ft (14 m) is for cast film without a pattern. Chrome or patterned film adds about 8 ft (2.5 m) because the pattern must be matched across panels.

Questions about wrapping a Mitsuoka Like

How much vinyl does it take to wrap a Mitsuoka Like?

It takes about 46 ft (14 m) of 60-inch (1.52 m) cast film to wrap a Mitsuoka Like. With chrome or patterned film, plan for about 54 ft (16.5 m). These figures are for the full five-door hatchback body. A partial wrap uses less film.

Can I wrap only the hood or the roof of a Like?

Yes, you can wrap only the hood or the roof of a Like. A partial wrap can also cover just the mirror caps or the window trim and badges. Paint protection film can be applied to the front end alone. These smaller jobs are standard options for this car.

Is a Like hard to wrap?

A Mitsuoka Like can be harder to wrap than a simple panel van. The tailgate has the rear glass in it, so the film must be cut to the glass edge. The charge port door is a small extra panel that needs its own piece. The body is compact at 140.6 in (3,570 mm), which makes tight curves around the bumpers exact work.

How many generations of the Like does this page cover?

This page covers one generation of the Mitsuoka Like. The first generation was produced from 2010 to 2012 as a five-door hatchback. No other generations of the Like are listed here.