Wraps by car

Mitsuoka Orochi wrap

A Mitsuoka Orochi wrap is a project for a vinyl wrap specialist, because this Japanese sports car has a striking mid-engine form and only one production generation, from 2006 to 2014. The car is a two-door convertible with a length of 179.5 inches (4,560 millimeters). A full vinyl wrap of the Orochi body uses about 44 feet (13.5 meters) of 60-inch (1.52-meter) cast film.

1generations13.5 mof film for a full wrap

Mitsuoka Orochi, first generation, factory photo
Mitsuoka Orochi, first generation. Factory color shown.

Mitsuoka Orochi wrap colors and ideas

  • Orochi black wrap
  • Orochi white wrap
  • Orochi gray wrap
  • Orochi silver wrap
  • Orochi red wrap
  • Orochi blue wrap
  • Orochi green wrap
  • Orochi yellow wrap
  • Orochi orange wrap
  • Orochi purple wrap
  • Orochi pink wrap
  • Orochi teal wrap
  • Orochi brown wrap
  • Orochi gold wrap
  • Orochi chrome wrap
  • Orochi color shift wrap
  • Orochi carbon fiber wrap
  • Orochi camo and patterned wrap

How much vinyl to wrap a Mitsuoka Orochi

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
2006–2014convertible (2 doors)179.5 in (4,560 mm)about 44 ft (13.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 59 ft (18 m)

Orochi wrap cost factors

Orochi wrap cost depends mainly on the size and complexity of the body, which is 179.5 inches (4,560 millimeters) long and built as a convertible. A full wrap uses about 44 feet (13.5 meters) of film, and the hours of labor are driven by the need to remove mirrors, handles, and trim around the open top. A chrome or patterned film increases the amount of film to about 59 feet (18 meters) and adds time for aligning the pattern across the car. The choice between a standard color change and a partial job such as a hood wrap changes the cost more than any other single factor.

  • Film for a full wrap: about 44 ft (13.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 59 ft (18 m).
  • Body: convertible (2 doors).
  • Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

Orochi wraps by generation

Swipe sideways. Tap a card for the full description.

Mitsuoka Orochi, first generation, factory photo
Factory color shown

2006–2014 Orochi convertible (first generation)

2006–2014convertible (2 doors)179.5 in (4,560 mm)

The first generation Mitsuoka Orochi is a convertible, and the open top changes the way a wrap is planned. The fabric top is not wrapped, so the film on the body ends where the fabric begins at the header rail and the tonneau cover. A folding hard top is wrapped as its own panels, and the seams between those panels must be cut open so the top can still fold. The wrap installer leaves a small edge of film tucked under the top seal to keep the line clean without interfering with the movement.

Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

Film: about 44 ft (13.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 59 ft (18 m).

Roof, hood, chrome delete and PPF on an Orochi

An Orochi chrome delete covers the window trim and badges with black film, leaving the painted body unchanged. A partial wrap on this car can be as small as the hood, mirror caps, or rear deck. Paint protection film (PPF) is a clear film applied to the front end to guard against stone chips without changing the color. These smaller jobs use less film and less time than a full wrap, but still require the same careful trim removal and cut-outs.

  • Partial wrap: hood, mirror caps, rear deck.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film on the front end, also over a wrap.

Wrapping a Mitsuoka Orochi: body, cut-outs and film

A Mitsuoka Orochi vinyl wrap must work around the car's convertible body, where the fabric or folding hard top is a separate element from the painted body panels. The car measures 179.5 inches (4,560 millimeters) long, which puts it in the range of a compact sports car for wrap film estimation. The two-door layout means fewer door jambs and handles to cut around than on a four-door car. However, the deeply sculpted sides and wide rear haunches add surface area and can require extra film for relief cuts.

Orochi wrap ideas often begin with how the open top is handled, because the fabric top is not wrapped and the film ends cleanly at its edge. The folding hard top, when fitted, is wrapped as panels of its own, so color changes can continue from the body without interruption. For cut-outs, the door handles, side mirrors, antenna base, and the small rear window are all trimmed or removed. The front and rear bumpers with their integrated vents and fins need careful inlays or relief cuts to keep the film anchored.

To find how much vinyl to wrap an Orochi, start with the published estimate of about 44 feet (13.5 meters) of 60-inch (1.52-meter) cast film for a standard color change wrap. This figure applies to the only generation sold, the 2006 to 2014 convertible with MSP1 chassis codes. If the film has a chrome or strong pattern that must be matched across panels, the estimate rises to about 59 feet (18 meters). The installer measures each body panel and adds waste for the deep curves of the fenders and the lower intake areas.

Questions about wrapping a Mitsuoka Orochi

How much vinyl does it take to wrap a Mitsuoka Orochi?

Yes, it takes about 44 feet (13.5 meters) of 60-inch (1.52-meter) cast vinyl to wrap a Mitsuoka Orochi. This figure is the estimate for a standard color change wrap on the 2006–2014 convertible. The amount covers the painted body panels and the small rear deck, but not the fabric top. If the film has a chrome or strong pattern, plan for about 59 feet (18 meters).

Is the top of an Orochi wrapped?

No, the top of an Orochi is not wrapped when it is a fabric convertible top. The film on the body ends where the fabric begins, with a clean edge at the header rail and tonneau. A folding hard top is wrapped as its own separate panels, and the seams are cut open so it can still fold. The wrapping of a hard top is included in the full body estimate.

Can I wrap only the hood or the roof of an Orochi?

Yes, you can wrap only the hood or the roof of an Orochi. A partial wrap on this car often covers the hood, mirror caps, or rear deck as separate pieces. The roof of the convertible is a fabric or folding hard top, and only the hard top version can be wrapped. A chrome delete of window trim and badges is another small job that does not require a full wrap.

Is an Orochi hard to wrap?

Yes, an Orochi is considered difficult to wrap because of its convertible top and deep body contours. The 179.5-inch (4,560-mm) body has wide rear fenders and large lower intakes that need careful inlays or relief cuts. The fabric top cannot be wrapped, so the installer must create a clean edge where film meets the cloth. If the car has a folding hard top, the extra panels and moving seams add more time to the job.