Wraps by car

Mitsuoka Yuga wrap

The Mitsuoka Yuga wrap page covers the first generation, produced from 2000 to 2002. This retro-styled minivan has one body style: a five-door van. A full vinyl wrap of the body takes about 57 ft (17.5 m) of 60-inch (1.52 m) cast film.

1generations17.5 mof film for a full wrap

Mitsuoka Yuga, first generation, factory photo
Mitsuoka Yuga, first generation. Factory color shown.

Mitsuoka Yuga wrap colors and ideas

  • Yuga black wrap
  • Yuga white wrap
  • Yuga gray wrap
  • Yuga silver wrap
  • Yuga red wrap
  • Yuga blue wrap
  • Yuga green wrap
  • Yuga yellow wrap
  • Yuga orange wrap
  • Yuga purple wrap
  • Yuga pink wrap
  • Yuga teal wrap
  • Yuga brown wrap
  • Yuga gold wrap
  • Yuga chrome wrap
  • Yuga color shift wrap
  • Yuga carbon fiber wrap
  • Yuga camo and patterned wrap

How much vinyl to wrap a Mitsuoka Yuga

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
2000–2002van (5 doors)161.8 in (4,110 mm)about 57 ft (17.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m)

Yuga wrap cost factors

Yuga wrap cost depends on the film, the prep work, and the installer's time. The van's 161.8 in (4,110 mm) length and five-door layout set the amount of film. Removing badges and working around sliding door tracks adds labor. A partial job on the roof or hood uses less film than a full wrap.

  • Film for a full wrap: about 57 ft (17.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m).
  • Body: van (5 doors).
  • Sliding side doors: the door tracks stay bare, and the film is cut along them.

Yuga wraps by generation

Swipe sideways. Tap a card for the full description.

Mitsuoka Yuga, first generation, factory photo
Factory color shown

2000–2002 Yuga van (first generation)

2000–2002van (5 doors)161.8 in (4,110 mm)

The first generation Mitsuoka Yuga was built from 2000 to 2002 as a five-door van. Its sliding side doors mean the tracks stay bare and decide where the film is cut. The body is 161.8 in (4,110 mm) long, so a standard wrap uses about 57 ft (17.5 m) of film.

Sliding side doors: the door tracks stay bare, and the film is cut along them.

Film: about 57 ft (17.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m).

Roof, hood, chrome delete and PPF on a Yuga

A partial wrap on the Yuga can cover the roof, hood, or mirror caps. For Yuga chrome delete, the window trim and badges are covered with black film. Paint protection film (PPF) is a clear film applied to the front end. These smaller jobs fit the retro look without a full color change wrap.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film on the front end, also over a wrap.

Wrapping a Mitsuoka Yuga: body, cut-outs and film

The Mitsuoka Yuga vinyl wrap starts with a body that is 161.8 in (4,110 mm) long. It is a five-door van, so most of the wrap work is on the tall sides and the rear hatch. The size is close to a small minivan, which makes film use predictable.

Yuga wrap ideas should account for the sliding side doors. The door tracks stay bare, and the film is cut along them. The door handles and badges come off for a clean install. You can also wrap the roof and mirror caps as separate pieces.

How much vinyl to wrap a Yuga depends on the film you choose. A standard color change wrap needs about 57 ft (17.5 m) of 60-inch (1.52 m) cast film. If you pick chrome or patterned film, order about 69 ft (21 m). This is the only generation in the catalog.

Questions about wrapping a Mitsuoka Yuga

How much vinyl does it take to wrap a Mitsuoka Yuga?

A full wrap of a Mitsuoka Yuga takes about 57 ft (17.5 m) of 60-inch (1.52 m) cast film. For chrome or patterned film, plan for about 69 ft (21 m). The estimate covers the first generation five-door van body.

Are the sliding doors of a Yuga wrapped?

No, the sliding door tracks of a Yuga stay bare. The film is cut along the tracks so the doors can still slide. The rest of the door panel is wrapped normally.

Can I wrap only the hood or the roof of a Yuga?

Yes, you can wrap only the hood or the roof of a Yuga. A partial wrap can also include the mirror caps. These small jobs are a good way to change the look without a full wrap.

Is a Yuga hard to wrap?

The Yuga is not the hardest car to wrap, but the sliding doors add work. The tracks must stay bare, so the film is cut along them. The five-door body and 161.8 in (4,110 mm) length mean more area than a coupe.