Wraps by car

Subaru R2 wrap

This page covers the Subaru R2 wrap, a single-generation kei car sold from 2003 to 2010. A full vinyl wrap of the body takes about 44 ft (13.5 m) of 60-inch (1.52 m) cast film. The R2 is a mini hatchback with five doors, so its small size keeps material needs low.

1generations13.5 mof film for a full wrap

Subaru R2, first generation, factory photo
Subaru R2, first generation. Factory color shown.

Subaru R2 wrap colors and ideas

  • Subaru R2 black wrap
  • Subaru R2 white wrap
  • Subaru R2 gray wrap
  • Subaru R2 silver wrap
  • Subaru R2 red wrap
  • Subaru R2 blue wrap
  • Subaru R2 green wrap
  • Subaru R2 yellow wrap
  • Subaru R2 orange wrap
  • Subaru R2 purple wrap
  • Subaru R2 pink wrap
  • Subaru R2 teal wrap
  • Subaru R2 brown wrap
  • Subaru R2 gold wrap
  • Subaru R2 chrome wrap
  • Subaru R2 color shift wrap
  • Subaru R2 carbon fiber wrap
  • Subaru R2 camo and patterned wrap

How much vinyl to wrap a Subaru R2

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
2003–2010hatchback (5 doors)133.7 in (3,395 mm)about 44 ft (13.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 52 ft (16 m)

Subaru R2 wrap cost factors

Subaru R2 wrap cost depends on film type, condition of the paint, and how much of the car is wrapped. The R2 is small, so a full wrap uses less material than a larger car, but labor for door jambs, the tailgate glass edge, and removing parts adds time. A color change wrap needs about 44 ft (13.5 m) of film, while specialized films take more. The final cost also reflects how much bodywork preparation the old paint needs.

  • Film for a full wrap: about 44 ft (13.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 52 ft (16 m).
  • Body: hatchback (5 doors).
  • A tailgate with the rear glass in it: the film ends at the edge of the glass.

Subaru R2 wraps by generation

Swipe sideways. Tap a card for the full description.

Subaru R2, first generation, factory photo
Factory color shown

2003–2010 Subaru R2 hatchback (first generation)

2003–2010hatchback (5 doors)133.7 in (3,395 mm)

The first generation Subaru R2 was built from 2003 to 2010 as a five-door hatchback. On a car of these years, panels may be original or repainted, and a test spot comes before a full wrap. Paint that is cracked or badly faded can fail under the film, so the surface must be checked first. Good adhesion on old paint often means extra cleaning and sometimes sanding.

A tailgate with the rear glass in it: the film ends at the edge of the glass.

Film: about 44 ft (13.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 52 ft (16 m).

Roof, hood, chrome delete and PPF on a Subaru R2

A partial wrap on the Subaru R2 can cover the roof, hood, or mirror caps without wrapping the whole car. Chrome delete on this model means covering the window trim and badges with black film. Paint protection film (PPF) is often applied as clear film on the front end to guard against stone chips. These smaller jobs use less film and can be done without removing the rear glass or tailgate trim.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Subaru R2: body, cut-outs and film

A Subaru R2 vinyl wrap follows the size of a 133.7 in (3,395 mm) long hatchback. Because the car is narrow and short, panel sections are small and the film can be worked around the sides without long stretches. The five-door layout adds door gaps and handles that need clean relief cuts. Wrapping the full body still requires planning the film around the round front and rear bumpers.

Subaru R2 wrap ideas begin with the tailgate, which has the rear glass set into it, so the film ends at the edge of the glass. The door handles, mirrors, and badges should come off or be cut around for a neat install. The rear wiper and the antenna base also need careful trimming. Keeping the film off the glass and rubber seals avoids lifting later.

How much vinyl to wrap a Subaru R2 depends on the generation, but this car has only one generation, the 2003–2010 hatchback. A color change wrap on this body uses about 44 ft (13.5 m) of 60-inch (1.52 m) cast film. For chrome or patterned film, plan on about 52 ft (16 m) because of pattern matching and extra waste. The single body style means the estimate stays the same across all production years.

Questions about wrapping a Subaru R2

How much vinyl does it take to wrap a Subaru R2?

It takes about 44 ft (13.5 m) of 60-inch (1.52 m) cast film to wrap a Subaru R2. That figure is for the 2003–2010 first generation, the only body style of this model. If you use chrome or patterned film, allow about 52 ft (16 m). The small size of the R2 keeps the material requirement lower than for many larger cars.

Can I wrap only the hood or the roof of a Subaru R2?

Yes, you can wrap only the hood or the roof of a Subaru R2. A partial wrap is a common job for a roof panel or hood, and mirror caps can be done alone as well. These sections are small and use less film than a full wrap. Chrome delete on the window trim and badges is another partial option for this car.

Is a Subaru R2 hard to wrap?

The Subaru R2 is not especially hard to wrap, but a few details add work. The tailgate has the rear glass set into it, so the film must end exactly at the glass edge. The car is only 133.7 in (3,395 mm) long, so panels are small and need precise trimming around handles and lights. Careful prep of the old paint is also needed on a car built from 2003 to 2010.

How many generations of the Subaru R2 does this page cover?

This page covers one generation of the Subaru R2. The first generation was sold from 2003 to 2010 as a five-door hatchback. There are no other generations of this model in the catalog.