Wraps by car

Subaru XT wrap

A Subaru XT wrap covers the first-generation coupe built from 1987 to 1992, and this page covers one generation. The car is 175.2 in (4,450 mm) long, and a full vinyl wrap of the body takes about 48 ft (14.5 m) of 60-inch (1.52 m) cast film. Chrome or patterned film adds roughly six feet of material.

1generations14.5 mof film for a full wrap

Subaru XT, first generation, factory photo
Subaru XT, first generation. Factory color shown.

Subaru XT wrap colors and ideas

  • Subaru XT black wrap
  • Subaru XT white wrap
  • Subaru XT gray wrap
  • Subaru XT silver wrap
  • Subaru XT red wrap
  • Subaru XT blue wrap
  • Subaru XT green wrap
  • Subaru XT yellow wrap
  • Subaru XT orange wrap
  • Subaru XT purple wrap
  • Subaru XT pink wrap
  • Subaru XT teal wrap
  • Subaru XT brown wrap
  • Subaru XT gold wrap
  • Subaru XT chrome wrap
  • Subaru XT color shift wrap
  • Subaru XT carbon fiber wrap
  • Subaru XT camo and patterned wrap

How much vinyl to wrap a Subaru XT

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1987–1992coupe (2 doors)175.2 in (4,450 mm)about 48 ft (14.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 54 ft (16.5 m)

Subaru XT wrap cost factors

Subaru XT wrap cost depends on the size of the coupe, the film chosen, and the paint condition on a car from 1987 to 1992. A full wrap takes about 48 ft (14.5 m) of 60-inch cast film, so material use is a major factor. The two long side doors are large pieces that take extra labor to lay flat without seams. Any paint repairs before the wrap add to the total.

  • Film for a full wrap: about 48 ft (14.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 54 ft (16.5 m).
  • Body: coupe (2 doors).
  • Two long side doors: each door is one large piece of film.

Subaru XT wraps by generation

Swipe sideways. Tap a card for the full description.

Subaru XT, first generation, factory photo
Factory color shown

1987–1992 Subaru XT coupe (first generation)

1987–1992coupe (2 doors)175.2 in (4,450 mm)

The first-generation Subaru XT was built from 1987 to 1992, and paint age on these cars can be original or repainted. A test spot on a panel comes before a full wrap to see how the film sticks and releases. The coupe body is 175.2 in (4,450 mm) long, and a full wrap takes about 48 ft (14.5 m) of 60-inch cast film.

Two long side doors: each door is one large piece of film.

Film: about 48 ft (14.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 54 ft (16.5 m).

Roof, hood, chrome delete and PPF on a Subaru XT

A partial wrap on a Subaru XT can cover the roof, hood, or mirror caps, which are smaller jobs than a full wrap. Subaru XT chrome delete covers the window trim and badges with black film, a clean way to change the look. Paint protection film, clear film on the front end, shields the nose from stone chips.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Subaru XT: body, cut-outs and film

Subaru XT vinyl wrap work follows the coupe's two long side doors, each of which is one large piece of film. The 175.2 in (4,450 mm) body is compact but all curved surfaces, so the installer works from the roof center outward to avoid bridging. A full wrap of the newest body takes about 48 ft (14.5 m) of 60-inch film.

Subaru XT wrap ideas often start with the two long side doors, which take one large sheet each and reward patient stretching. The window trim and badges are prime spots for chrome delete, where bright trim is covered with black film. The front end can be covered with paint protection film (PPF) to guard the nose against road debris.

How much vinyl to wrap a Subaru XT depends on the generation, but the page covers only the first generation from 1987 to 1992. A full wrap of the coupe body takes about 48 ft (14.5 m) of 60-inch cast film. If the film has a chrome or pattern, the estimate rises to about 54 ft (16.5 m).

Questions about wrapping a Subaru XT

How much vinyl does it take to wrap a Subaru XT?

A full wrap of a Subaru XT takes about 48 ft (14.5 m) of 60-inch (1.52 m) cast film. That figure is for the first-generation coupe body from 1987 to 1992. If you choose chrome or patterned film, plan on about 54 ft (16.5 m).

Can I wrap only the hood or the roof of a Subaru XT?

Yes, you can wrap only the hood or the roof of a Subaru XT. The partial wrap options for this car include the roof, hood, or mirror caps. You can also do a chrome delete on the window trim and badges.

Is a Subaru XT hard to wrap?

A Subaru XT is not especially hard to wrap, but the two long side doors are large pieces that take careful stretching. The coupe body is 175.2 in (4,450 mm) long, which means long panels. The windows are fixed and the trim is simple, so there are no heavy cut-outs.

How many generations of the Subaru XT does this page cover?

This page covers one generation of the Subaru XT. The only body in the catalog is the first generation, built from 1987 to 1992. It is a two-door coupe.