Wraps by car

Toyota Avensis Verso wrap

The Toyota Avensis Verso wrap page covers this seven-seat minivan produced from 2001 to 2009. A full vinyl wrap of the newest body uses about 69 ft (21 m) of 60-inch (1.52 m) cast film. This page explains how the sliding doors shape the film cuts and what smaller wrap jobs are possible.

1generations21 mof film for a full wrap

Toyota Avensis Verso, first generation, factory photo
Toyota Avensis Verso, first generation. Factory color shown.

Toyota Avensis Verso wrap colors and ideas

  • Avensis Verso black wrap
  • Avensis Verso white wrap
  • Avensis Verso gray wrap
  • Avensis Verso silver wrap
  • Avensis Verso red wrap
  • Avensis Verso blue wrap
  • Avensis Verso green wrap
  • Avensis Verso yellow wrap
  • Avensis Verso orange wrap
  • Avensis Verso purple wrap
  • Avensis Verso pink wrap
  • Avensis Verso teal wrap
  • Avensis Verso brown wrap
  • Avensis Verso gold wrap
  • Avensis Verso chrome wrap
  • Avensis Verso color shift wrap
  • Avensis Verso carbon fiber wrap
  • Avensis Verso camo and patterned wrap

How much vinyl to wrap a Toyota Avensis Verso

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
2001–2009van (5 doors)183.1 in (4,650 mm) to 184.6 in (4,690 mm)about 69 ft (21 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 80 ft (24.5 m)

Avensis Verso wrap cost factors

The Avensis Verso wrap cost depends on the film area of this 183.1 in (4,650 mm) to 184.6 in (4,690 mm) long minivan. A full wrap uses about 69 ft (21 m) of cast film, and chrome or patterned film takes about 80 ft (24.5 m). The sliding door tracks add cutting time but not extra film. Jobs like a roof wrap or a hood wrap use less film and take fewer hours.

  • Film for a full wrap: about 69 ft (21 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 80 ft (24.5 m).
  • Body: van (5 doors).
  • Sliding side doors: the door tracks stay bare, and the film is cut along them.
  • Restyled in 2003: bumpers and lights differ between the versions, and so do the film cuts.

Avensis Verso wraps by generation

Swipe sideways. Tap a card for the full description.

Toyota Avensis Verso, first generation, factory photo
Factory color shown

2001–2009 Avensis Verso van (first generation)

2001–2009van (5 doors)183.1 in (4,650 mm) to 184.6 in (4,690 mm)

The first generation Toyota Avensis Verso was built from 2001 to 2009 as a five-door van and restyled in 2003. The sliding side doors are the main wrap point: the tracks stay bare, and the film is cut along them. The restyling changed the front bumper and lights but not the door shape. A full wrap of this body uses about 69 ft (21 m) of 60-inch (1.52 m) cast film.

Sliding side doors: the door tracks stay bare, and the film is cut along them.

Film: about 69 ft (21 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 80 ft (24.5 m).

Roof, hood, chrome delete and PPF on an Avensis Verso

Partial wrap on an Avensis Verso covers the roof, hood, or mirror caps as separate jobs. Avensis Verso chrome delete covers the window trim and badges with black film. Paint protection film (PPF) is clear film applied to the front end to guard against stone chips. These smaller jobs use less film than a full wrap and can be done without removing the sliding doors.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Toyota Avensis Verso: body, cut-outs and film

The Toyota Avensis Verso vinyl wrap follows the simple shape of a five-door van with a length between 183.1 in (4,650 mm) and 184.6 in (4,690 mm). The large side panels make for long, straight film pieces with few body lines to work around. The sliding door tracks run below the rear side windows and stay bare. That leaves a clean horizontal edge where the film is cut along the track.

Avensis Verso wrap ideas start with the sliding side doors, because their tracks must stay bare and decide where the film is cut. The door handles and badges come off for a clean install, and the mirror caps are wrapped separately. The roof has rain gutters that the film is trimmed into rather than wrapped over. The front and rear bumpers need relief cuts around the license plate areas and the rear hatch handle.

How much vinyl to wrap an Avensis Verso depends on the film and the body length. A plain color change wrap on the 2001 to 2009 van needs about 69 ft (21 m) of 60-inch (1.52 m) cast film. Chrome or patterned film takes about 80 ft (24.5 m) because the pattern must be matched across panels. The one generation in the catalog was restyled in 2003, but the length changed by only 1.5 in (40 mm).

Questions about wrapping a Toyota Avensis Verso

How much vinyl does it take to wrap a Toyota Avensis Verso?

A full vinyl wrap of a Toyota Avensis Verso takes about 69 ft (21 m) of 60-inch (1.52 m) cast film. That figure covers a plain color change wrap on the newest body, which is 183.1 in (4,650 mm) to 184.6 in (4,690 mm) long. Chrome or patterned film takes about 80 ft (24.5 m) because the pattern must be matched across panels.

Are the sliding doors of an Avensis Verso wrapped?

Yes, the sliding doors of an Avensis Verso are wrapped, but the tracks stay bare. The film is cut along the track line so the door can slide without rubbing. That cut is the main technical point on this van, and the doors themselves take large, flat pieces of film.

Which years of the Avensis Verso take the same film cuts?

All years of the Toyota Avensis Verso take the same film cuts for the body sides and doors. The model was built from 2001 to 2009 and restyled in 2003, but the sliding door tracks and panel shapes did not change. The restyling only affected the front bumper and lights, so the film cuts there differ slightly.

Can I wrap only the hood or the roof of an Avensis Verso?

Yes, you can wrap only the hood or the roof of an Avensis Verso as a partial wrap. The mirror caps can be wrapped separately too, and chrome delete covers the window trim and badges. Paint protection film (PPF) is also applied to just the front end as a clear protective layer.