Wraps by car

Toyota Cami wrap

The Toyota Cami is covered in one generation in this catalog. This page covers the first generation SUV produced from 1999 to 2006. A full wrap of this body takes about 51 ft (15.5 m) of 60-inch (1.52 m) cast film. For chrome or patterned vinyl wrap, the estimate is about 57 ft (17.5 m).

1generations15.5 mof film for a full wrap

Toyota Cami, first generation, factory photo
Toyota Cami, first generation. Factory color shown.

Toyota Cami wrap colors and ideas

  • Cami black wrap
  • Cami white wrap
  • Cami gray wrap
  • Cami silver wrap
  • Cami red wrap
  • Cami blue wrap
  • Cami green wrap
  • Cami yellow wrap
  • Cami orange wrap
  • Cami purple wrap
  • Cami pink wrap
  • Cami teal wrap
  • Cami brown wrap
  • Cami gold wrap
  • Cami chrome wrap
  • Cami color shift wrap
  • Cami carbon fiber wrap
  • Cami camo and patterned wrap

How much vinyl to wrap a Toyota Cami

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1999–2006SUV (5 doors)149.0 in (3,785 mm)about 51 ft (15.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 57 ft (17.5 m)

Cami wrap cost factors

Cami wrap cost depends on the amount of film and the labor for this compact SUV. A full wrap needs about 51 ft (15.5 m) of 60-inch (1.52 m) cast film, while chrome or patterned film needs about 57 ft (17.5 m). The body has five doors and a tailgate, which adds time for cut-outs and trim removal. Paint condition on a 1999–2006 car also affects the amount of preparation.

  • Film for a full wrap: about 51 ft (15.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 57 ft (17.5 m).
  • Body: SUV (5 doors).
  • A tailgate with the rear glass in it: the film ends at the edge of the glass.

Cami wraps by generation

Swipe sideways. Tap a card for the full description.

Toyota Cami, first generation, factory photo
Factory color shown

1999–2006 Cami SUV (first generation)

1999–2006SUV (5 doors)149.0 in (3,785 mm)

The first-generation Cami from 1999 to 2006 may have original or repainted panels at this age. A test spot on a small area of paint comes before a full wrap. The body is the same for all years of this generation, so film measurements do not change. The compact size of 149.0 in (3,785 mm) keeps the wrap area low for an SUV.

A tailgate with the rear glass in it: the film ends at the edge of the glass.

Film: about 51 ft (15.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 57 ft (17.5 m).

Roof, hood, chrome delete and PPF on a Cami

A partial wrap on a Cami can cover the roof, the hood, or the mirror caps. Cami chrome delete covers the window trim and badges with black film instead of bright trim. Paint protection film (PPF) is clear film applied to the front end of the vehicle. These partial jobs use less material than a full wrap and focus on one part of the SUV.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Toyota Cami: body, cut-outs and film

A Toyota Cami vinyl wrap covers one SUV body style with five doors. The car measures 149.0 in (3,785 mm) in length, which keeps the wrap area compact. Its upright sides and flat panels help film lay down with fewer relief cuts. The tailgate is included in the wrap and is part of the body surface.

Cami wrap ideas often start with the tailgate because the rear glass is set into it. The film ends at the edge of the glass and the glass itself is not wrapped. For other parts, the mirrors, door handles, and badges are removed for a clean install. The roof rails and antenna, if fitted, are also taken off before wrapping the roof.

To know how much vinyl to wrap a Cami, measure once because there is only one generation. The first generation ran from 1999 through 2006 and all years share the same body. Film use stays the same for the whole run at about 51 ft (15.5 m) of 60-inch (1.52 m) cast film. If you choose chrome or patterned film, add about 6 ft (1.8 m).

Questions about wrapping a Toyota Cami

How much vinyl does it take to wrap a Toyota Cami?

A Toyota Cami takes about 51 ft (15.5 m) of 60-inch (1.52 m) cast film for a full wrap. For chrome or patterned film, the amount is about 57 ft (17.5 m). These figures are for the first-generation body from 1999 to 2006.

Can I wrap only the hood or the roof of a Cami?

Yes, you can wrap only the hood or the roof of a Cami. Partial wrap options for this SUV include the roof, hood, and mirror caps. A chrome delete for the window trim and badges is another separate job. Paint protection film on the front end is also possible without a full wrap.

Is a Cami hard to wrap?

A Cami is not the hardest SUV to wrap, but a few details add time. The tailgate has the rear glass set into it, so the film ends at the edge of the glass. The five-door body and the 149.0 in (3,785 mm) length mean several cut-outs for handles and trim. Removing the roof rails and antenna, if fitted, also adds steps to the job.

How many generations of the Cami does this page cover?

This page covers one generation of the Cami, from 1999 to 2006. All years of the first generation share the same SUV body style with five doors and the same dimensions. The wrap film amounts and installation details apply to the whole generation.