Wraps by car

Toyota Classic wrap

This page covers the Toyota Classic wrap, the single body sold from 1996 to 1997 under code YN86. A full Toyota Classic vinyl wrap of the four-door sedan takes about 61 ft (18.5 m) of 60-inch (1.52 m) cast film. With chrome or patterned film the estimate rises to about 69 ft (21 m). One generation is covered in this catalog.

1generations18.5 mof film for a full wrap

Toyota Classic, first generation, factory photo
Toyota Classic, first generation. Factory color shown.

Toyota Classic wrap colors and ideas

  • Classic black wrap
  • Classic white wrap
  • Classic gray wrap
  • Classic silver wrap
  • Classic red wrap
  • Classic blue wrap
  • Classic green wrap
  • Classic yellow wrap
  • Classic orange wrap
  • Classic purple wrap
  • Classic pink wrap
  • Classic teal wrap
  • Classic brown wrap
  • Classic gold wrap
  • Classic chrome wrap
  • Classic color shift wrap
  • Classic carbon fiber wrap
  • Classic camo and patterned wrap

How much vinyl to wrap a Toyota Classic

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1996–1997sedan (4 doors)192.3 in (4,885 mm)about 61 ft (18.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m)

Classic wrap cost factors

Classic wrap cost is set by the size of the YN86 sedan and the work its panels need. A full wrap calls for about 61 ft (18.5 m) of 60-inch (1.52 m) film, and a chrome or patterned film raises that to about 69 ft (21 m). The condition of the paint after 1996 to 1997 also changes how much prep is charged. Removing trims, badges and lights adds labor on this car.

  • Film for a full wrap: about 61 ft (18.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m).
  • Body: sedan (4 doors).

Classic wraps by generation

Swipe sideways. Tap a card for the full description.

Toyota Classic, first generation, factory photo
Factory color shown

1996–1997 Classic sedan (first generation)

1996–1997sedan (4 doors)192.3 in (4,885 mm)

The Toyota Classic was built with the first generation YN86 body only from 1996 to 1997. On a car of this age the panels may still hold original paint or they may be repainted, which a wrap shop checks before quoting. A test spot on one panel shows whether the film can be removed later without pulling the paint. The four-door sedan is the sole body style in this catalog.

Film: about 61 ft (18.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m).

Roof, hood, chrome delete and PPF on a Classic

A partial wrap on a Toyota Classic can be the roof, the hood or the mirror caps for a smaller change. A Classic chrome delete covers the window trim and the badges with black film. Paint protection film (PPF) is another choice, a clear film laid on the front end of the YN86. Each job uses far less than the full 61 ft (18.5 m) the whole body takes.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Toyota Classic: body, cut-outs and film

A Toyota Classic vinyl wrap has to follow the long, flat panels of the 192.3 in (4,885 mm) sedan. The four doors and the roof add joined seams that the installer works through carefully. This body shape gives wide, smooth areas where a one-piece film lays well. The size makes a single install heavier, but the panel shapes stay simple.

Classic wrap ideas start with what has to come off the Toyota Classic before film goes on. Door handles, mirrors, lights and the grille are removed so the film tucks behind each edge. The window trims and the badges are also taken off if those pieces get wrapped or deleted. Reinstalling them after the film is laid keeps the cut lines clean.

How much vinyl to wrap a Classic depends on whether the car has original paint or an older repaint, because only one generation exists in the catalog. The first-generation YN86 sedan is the only body used from 1996 to 1997, so the film estimate stays about 61 ft (18.5 m). A test spot on the paint shows if the film will lift old layers. There are no later bodies for those who count film between generations.

Questions about wrapping a Toyota Classic

How much vinyl does it take to wrap a Toyota Classic?

About 61 ft (18.5 m) of 60-inch (1.52 m) cast film is needed to wrap a Toyota Classic. That is the estimate for the YN86 four-door sedan sold from 1996 to 1997. If the wrap uses chrome or patterned film, the amount goes up to about 69 ft (21 m).

Can I wrap only the hood or the roof of a Classic?

Yes, the hood or the roof of a Classic can be wrapped on its own. A partial wrap may also be the mirror caps. These smaller jobs take much less film than the full 61 ft (18.5 m) a whole-body wrap uses.

Is a Classic hard to wrap?

A Classic is not a hard car to wrap, but the first-generation YN86 sedan has points that add work. The four doors and the 192.3 in (4,885 mm) body length mean long film panels and several seams to manage. Wrap installers also remove the door handles, mirrors, lights and grille before film goes on.

How many generations of the Classic does this page cover?

This page covers one generation of the Classic, the first generation sold from 1996 to 1997. The single body is the YN86 four-door sedan. No other Classic generation is in this catalog.