Wraps by car

Toyota Corona EXiV wrap

The Toyota Corona EXiV wrap page covers the two generations of this mid-size sedan built from 1989 to 1998. A full vinyl wrap of the newest body takes about 51 ft (15.5 m) of 60-inch (1.52 m) cast film. Chrome or patterned film raises the estimate to about 62 ft (19 m). Both generations share the same four-door sedan body and length of 177.2 in (4,500 mm).

2generations15.5 mof film for a full wrap

Toyota Corona EXiV, second generation, factory photo
Toyota Corona EXiV, second generation. Factory color shown.

Toyota Corona EXiV wrap colors and ideas

  • Corona EXiV black wrap
  • Corona EXiV white wrap
  • Corona EXiV gray wrap
  • Corona EXiV silver wrap
  • Corona EXiV red wrap
  • Corona EXiV blue wrap
  • Corona EXiV green wrap
  • Corona EXiV yellow wrap
  • Corona EXiV orange wrap
  • Corona EXiV purple wrap
  • Corona EXiV pink wrap
  • Corona EXiV teal wrap
  • Corona EXiV brown wrap
  • Corona EXiV gold wrap
  • Corona EXiV chrome wrap
  • Corona EXiV color shift wrap
  • Corona EXiV carbon fiber wrap
  • Corona EXiV camo and patterned wrap

How much vinyl to wrap a Toyota Corona EXiV

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1993–1998sedan (4 doors)177.2 in (4,500 mm)about 51 ft (15.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 62 ft (19 m)
1989–1993sedan (4 doors)177.2 in (4,500 mm)about 51 ft (15.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 62 ft (19 m)

Corona EXiV wrap cost factors

Corona EXiV wrap cost depends on the amount of film, the size of the car and the work in the panels. The car is 177.2 in (4,500 mm) long, which sets the base material at about 51 ft (15.5 m) of 60-inch (1.52 m) film. A chrome delete on the window trim and badges adds labor for small, precise cuts. If the film has a chrome or pattern finish, the material need rises to about 62 ft (19 m) and drives the cost up.

  • Film for a full wrap: about 51 ft (15.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 62 ft (19 m).
  • Body: sedan (4 doors).

Corona EXiV wraps by generation

Swipe sideways. Tap a card for the full description.

Toyota Corona EXiV, second generation, factory photo
Factory color shown

1993–1998 Corona EXiV sedan (second generation)

1993–1998sedan (4 doors)177.2 in (4,500 mm)

The second generation Toyota Corona EXiV was built from 1993 to 1998 as a four-door sedan. Paint age matters on a car of these years: panels may be original or repainted, so a test spot comes before a full wrap. The installer checks that the film will not lift old paint when it is repositioned or removed. If the paint is sound, the wrap can go ahead.

Film: about 51 ft (15.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 62 ft (19 m).

Toyota Corona EXiV, first generation, factory photo
Factory color shown

1989–1993 Corona EXiV sedan (first generation)

1989–1993sedan (4 doors)177.2 in (4,500 mm)

The first generation Toyota Corona EXiV was built from 1989 to 1993 as a four-door sedan. The size and the body style of this car mean the film amount and the number of panels are the same as on the second generation. It takes about 51 ft (15.5 m) of 60-inch (1.52 m) cast film for a full wrap. The sedan shape has no large flat sides, so the installer works panel by panel.

Film: about 51 ft (15.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 62 ft (19 m).

Roof, hood, chrome delete and PPF on a Corona EXiV

A Corona EXiV chrome delete covers the window trim and badges with black film. A partial wrap can cover the roof, hood or mirror caps on their own. Paint protection film (PPF) goes on the front end as a clear film to guard against stone chips. These smaller jobs use less material than a full wrap and can be done without wrapping the whole car.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Toyota Corona EXiV: body, cut-outs and film

A Toyota Corona EXiV vinyl wrap covers one body style: a four-door sedan with a length of 177.2 in (4,500 mm). The car has no long roof rails or large boxy rear, so panel sizes stay close to those of other mid-size sedans. The front and rear bumpers, the hood, the trunk lid and the four doors are the main wrapped panels. The roof is a straightforward single panel, which keeps the cutting plan simple.

Corona EXiV wrap ideas start with removing the door handles, mirrors, badges, trim pieces and the front and rear bumpers where possible. The door handles and mirrors come off, so the film can wrap around their edges without visible seams. The window trim and badges are small parts that a chrome delete can cover in black film. The front bumper has several openings and curves, so it takes more time to lay the film cleanly.

How much vinyl to wrap a Corona EXiV depends on the generation only through the production years, because the body dimensions are the same. Both the T200 series from 1993 to 1998 and the ST180 series from 1989 to 1993 measure 177.2 in (4,500 mm) long. The film estimate is about 51 ft (15.5 m) of 60-inch (1.52 m) cast film for a standard color change. The estimate for chrome or patterned film is about 62 ft (19 m) because matching patterns needs extra material.

Questions about wrapping a Toyota Corona EXiV

How much vinyl does it take to wrap a Toyota Corona EXiV?

About 51 ft (15.5 m) of 60-inch (1.52 m) cast film is needed to wrap a Toyota Corona EXiV. That figure is for the newest body, the T200 series sedan. If the film has a chrome or pattern finish, the amount rises to about 62 ft (19 m).

Can I wrap only the hood or the roof of a Corona EXiV?

Yes, you can wrap only the hood or the roof of a Corona EXiV. The partial wrap options for this car include the roof, the hood and the mirror caps. You can also cover the front end with clear paint protection film (PPF).

Is a Corona EXiV hard to wrap?

A Corona EXiV is not especially hard to wrap, but the front bumper adds work with its openings and curves. The four doors and the bumpers are standard for a mid-size sedan. The car is 177.2 in (4,500 mm) long, which is a typical size for a sedan wrap. Removing the mirrors, handles and trim before wrapping makes the job cleaner.

How many generations of the Corona EXiV does this page cover?

This page covers two generations of the Toyota Corona EXiV. The first generation was built from 1989 to 1993 and the second from 1993 to 1998. Both are four-door sedans with the same length, so the wrap data applies to both.