Passo Sette wrap cost depends mainly on the film the owner picks and the labor for the sliding doors, which need careful cutting around the tracks on both sides of this 165.2 in (4,195 mm) van. A full wrap uses about 61 ft (18.5 m) of cast film, so a premium color or satin finish raises the material portion of the job more than a basic gloss. The five-door body and tall roof mean the installer spends more time on the roof panel and the four door cut-outs than on a small hatchback. Removing and refitting the door handles, mirrors and badges adds labor, so a wrap with every part removed costs more than one where the film is trimmed around them.

2008–2012 Passo Sette van (first generation)
The first generation Passo Sette, built from 2008 to 2012, has sliding side doors, and the tracks stay bare and decide where the film is cut on every wrap. The lower edge of the side film has to stop a few millimeters above the track channel, which leaves a visible paint line unless the owner chooses a dark film close to the body color. Because the track runs the whole length of the door opening, the installer cannot wrap the lower rocker panel as one piece with the door, so the side is split into more sections than on a car with normal hinges. This generation also has a tall, nearly flat roof, so the roof panel needs a full sheet of film with no seams unless the owner accepts a visible overlap.
Sliding side doors: the door tracks stay bare, and the film is cut along them.
Film: about 61 ft (18.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 70 ft (21.5 m).