Wraps by car

Dodge Dynasty wrap

The Dodge Dynasty wrap page covers the single generation of this mid-size sedan, produced from 1987 to 1993. A full vinyl wrap on a 1993 Dodge Dynasty takes about 54 ft (16.5 m) of 60-inch (1.52 m) cast film. Plan for about 66 ft (20 m) if you choose chrome or patterned film.

1generations16.5 mof film for a full wrap

Dodge Dynasty, first generation, factory photo
Dodge Dynasty, first generation. Factory color shown.

Dodge Dynasty wrap colors and ideas

  • Dynasty black wrap
  • Dynasty white wrap
  • Dynasty gray wrap
  • Dynasty silver wrap
  • Dynasty red wrap
  • Dynasty blue wrap
  • Dynasty green wrap
  • Dynasty yellow wrap
  • Dynasty orange wrap
  • Dynasty purple wrap
  • Dynasty pink wrap
  • Dynasty teal wrap
  • Dynasty brown wrap
  • Dynasty gold wrap
  • Dynasty chrome wrap
  • Dynasty color shift wrap
  • Dynasty carbon fiber wrap
  • Dynasty camo and patterned wrap

How much vinyl to wrap a Dodge Dynasty

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1987–1993sedan (4 doors)192.0 in (4,877 mm)about 54 ft (16.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 66 ft (20 m)

Dynasty wrap cost factors

Dynasty wrap cost depends on the amount of film, the film type, and the labor for the sedan's 192.0 in (4,877 mm) body. A full wrap uses about 54 ft (16.5 m) of cast film, while chrome or patterned film requires about 66 ft (20 m). Paint condition also affects cost, as old or repainted panels may need more preparation.

  • Film for a full wrap: about 54 ft (16.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 66 ft (20 m).
  • Body: sedan (4 doors).

Dynasty wraps by generation

Swipe sideways. Tap a card for the full description.

Dodge Dynasty, first generation, factory photo
Factory color shown

1987–1993 Dynasty sedan (first generation)

1987–1993sedan (4 doors)192.0 in (4,877 mm)

The first generation Dodge Dynasty was built from 1987 to 1993 as a four-door sedan. On a car of these years, panels may be original or repainted, and a test spot comes before a full wrap. The installer should check paint adhesion on each panel before applying the vinyl.

Film: about 54 ft (16.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 66 ft (20 m).

Roof, hood, chrome delete and PPF on a Dynasty

The Dodge Dynasty partial wrap can cover the roof, hood, or mirror caps instead of the whole car. Chrome delete wraps the window trim and badges with black film, while paint protection film (PPF) is a clear film applied to the front end. These smaller jobs use less film than a full wrap.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film on the front end, also over a wrap.

Wrapping a Dodge Dynasty: body, cut-outs and film

The Dodge Dynasty vinyl wrap is for a mid-size four-door sedan with a length of 192.0 in (4,877 mm). This body style has a large roof, hood, and trunk lid, but the rocker panels are relatively short. The wrap installer will cut the film to fit each panel, so waste is low on a sedan of this size.

Dynasty wrap ideas include covering the chrome window trim and badges with black film, a technique called chrome delete. The door handles, mirrors, and antenna need careful cut-outs, and the bumpers may be removed for better film adhesion. The tail light surrounds can be wrapped, but the lights themselves remain uncovered.

To calculate how much vinyl to wrap a Dynasty, note that only one generation exists, so the body size does not change between years. The car was produced from 1987 to 1993, and all years share the same sedan body. You will need about 54 ft (16.5 m) of film for any model year.

Questions about wrapping a Dodge Dynasty

How much vinyl does it take to wrap a Dodge Dynasty?

A Dodge Dynasty needs about 54 ft (16.5 m) of 60-inch (1.52 m) cast film for a full wrap. If the film is chrome or patterned, plan for about 66 ft (20 m). This estimate covers the sedan body of the single generation produced from 1987 to 1993.

Can I wrap only the hood or the roof of a Dynasty?

Yes, you can wrap only the hood or the roof of a Dynasty. Partial wrap options include the roof, hood, and mirror caps, and they use less film than a full wrap. Chrome delete on the window trim and badges is another small job, as is clear paint protection film on the front end.

Is a Dynasty hard to wrap?

A Dodge Dynasty has a mid-size sedan body that is 192.0 in (4,877 mm) long, which adds some work to wrap. The door handles, mirrors, and antenna require cut-outs, and the bumpers may be removed for better adhesion. The large roof and hood also need careful film stretching.

How many generations of the Dynasty does this page cover?

This page covers one generation of the Dodge Dynasty, produced from 1987 to 1993. The car was sold as a four-door sedan throughout its run, with no other body styles. All model years share the same dimensions, so the film estimate does not change.