Wraps by car

Lincoln Mark IV wrap

This page covers the Lincoln Mark IV wrap, including vinyl wrap for the single generation produced from 1972 to 1976. The Mark IV is a luxury coupe with two doors and an overall length of 228.1 in (5,794 mm). A full wrap of this body takes about 61 ft (18.5 m) of 60-inch (1.52 m) cast film, or about 80 ft (24.5 m) if chrome or patterned film is used.

1generations18.5 mof film for a full wrap

Lincoln Mark IV, first generation, factory photo
Lincoln Mark IV, first generation. Factory color shown.

Lincoln Mark IV wrap colors and ideas

  • Mark IV black wrap
  • Mark IV white wrap
  • Mark IV gray wrap
  • Mark IV silver wrap
  • Mark IV red wrap
  • Mark IV blue wrap
  • Mark IV green wrap
  • Mark IV yellow wrap
  • Mark IV orange wrap
  • Mark IV purple wrap
  • Mark IV pink wrap
  • Mark IV teal wrap
  • Mark IV brown wrap
  • Mark IV gold wrap
  • Mark IV chrome wrap
  • Mark IV color shift wrap
  • Mark IV carbon fiber wrap
  • Mark IV camo and patterned wrap

How much vinyl to wrap a Lincoln Mark IV

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1972–1976coupe (2 doors)228.1 in (5,794 mm)about 61 ft (18.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 80 ft (24.5 m)

Mark IV wrap cost factors

Mark IV wrap cost depends mostly on the film, the condition of the paint, and how much of the car is wrapped. The long coupe body is 228.1 in (5,794 mm) and takes about 61 ft (18.5 m) of 60-inch (1.52 m) cast film for a full color change. If you pick chrome or patterned film, the amount goes up to about 80 ft (24.5 m). Paint correction before wrapping adds work, and a test spot on older paint is wise.

  • Film for a full wrap: about 61 ft (18.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 80 ft (24.5 m).
  • Body: coupe (2 doors).
  • Two long side doors: each door is one large piece of film.

Mark IV wraps by generation

Swipe sideways. Tap a card for the full description.

Lincoln Mark IV, first generation, factory photo
Factory color shown

1972–1976 Mark IV coupe (first generation)

1972–1976coupe (2 doors)228.1 in (5,794 mm)

The first generation Lincoln Mark IV ran from 1972 to 1976 as a two-door coupe. Paint age matters on a car of these years: panels may be original or repainted. Before a full wrap, a test spot on the paint shows whether the film will adhere well. If the paint is flaking, it needs repair before the vinyl goes on.

Two long side doors: each door is one large piece of film.

Film: about 61 ft (18.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 80 ft (24.5 m).

Roof, hood, chrome delete and PPF on a Mark IV

A partial wrap on a Mark IV can cover the roof, hood, or mirror caps. A chrome delete covers the window trim and badges with black film. Paint protection film (PPF) is clear film applied to the front end. These smaller jobs use less vinyl than a full wrap and can be done on their own.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film on the front end, also over a wrap.

Wrapping a Lincoln Mark IV: body, cut-outs and film

The Lincoln Mark IV vinyl wrap is shaped by a two-door coupe body that is 228.1 in (5,794 mm) long. Each door is a large single piece of film, which needs careful handling to avoid creases. The long roof and rear quarters add surface area, and the wrap uses about 61 ft (18.5 m) of 60-inch (1.52 m) cast film. With chrome or patterned film the estimate rises to about 80 ft (24.5 m).

Mark IV wrap ideas start with the two long side doors, which each take one large piece of film and no seams. The window trim and badges are often covered with black film in a chrome delete. For paint protection film (PPF), the front end is the usual area to cover with clear film. Removing the door handles and mirrors gives a cleaner edge around these parts.

How much vinyl to wrap a Mark IV depends on the single generation made from 1972 to 1976. The body length stayed at 228.1 in (5,794 mm) across those years, so the same cut list works for any Mark IV. A full wrap of this coupe takes about 61 ft (18.5 m) of 60-inch (1.52 m) cast film. If you choose chrome or patterned film, plan for about 80 ft (24.5 m).

Questions about wrapping a Lincoln Mark IV

How much vinyl does it take to wrap a Lincoln Mark IV?

A full wrap of a Lincoln Mark IV takes about 61 ft (18.5 m) of 60-inch (1.52 m) cast film. If you choose chrome or patterned film, the amount is about 80 ft (24.5 m). These figures are for the coupe body from 1972 to 1976.

Can I wrap only the hood or the roof of a Mark IV?

Yes, you can wrap only the hood or the roof of a Mark IV. Partial wraps often include the roof, hood, and mirror caps. A chrome delete covers the window trim and badges. Paint protection film (PPF) is another partial job that protects the front end.

Is a Mark IV hard to wrap?

The Mark IV is not especially hard to wrap, but the large doors and long body add some work. Each door is one large piece of film, so an extra pair of hands helps. The car is 228.1 in (5,794 mm) long, which means more film to handle at once.

How many generations of the Mark IV does this page cover?

This page covers one generation of the Mark IV, produced from 1972 to 1976. All Mark IVs from those years share the same coupe body and dimensions.