Wraps by car

Nissan Liberty wrap

The Nissan Liberty wrap page covers the first generation van produced from 1998 to 2004. This single body style is a five-door minivan known as the M12. A full wrap of this body takes about 57 ft (17.5 m) of 60-inch (1.52 m) cast vinyl wrap.

1generations17.5 mof film for a full wrap

Nissan Liberty, first generation, factory photo
Nissan Liberty, first generation. Factory color shown.

Nissan Liberty wrap colors and ideas

  • Liberty black wrap
  • Liberty white wrap
  • Liberty gray wrap
  • Liberty silver wrap
  • Liberty red wrap
  • Liberty blue wrap
  • Liberty green wrap
  • Liberty yellow wrap
  • Liberty orange wrap
  • Liberty purple wrap
  • Liberty pink wrap
  • Liberty teal wrap
  • Liberty brown wrap
  • Liberty gold wrap
  • Liberty chrome wrap
  • Liberty color shift wrap
  • Liberty carbon fiber wrap
  • Liberty camo and patterned wrap

How much vinyl to wrap a Nissan Liberty

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1998–2004van (5 doors)180.1 in (4,575 mm)about 57 ft (17.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 72 ft (22 m)

Liberty wrap cost factors

A Liberty wrap cost depends on the amount of film, which is about 57 ft (17.5 m), and the labour for a 180.1 in (4,575 mm) van body. Chrome or patterned film raises the material estimate to about 72 ft (22 m). Removing parts and working around the sliding door tracks add time to the job.

  • Film for a full wrap: about 57 ft (17.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 72 ft (22 m).
  • Body: van (5 doors).
  • Sliding side doors: the door tracks stay bare, and the film is cut along them.

Liberty wraps by generation

Swipe sideways. Tap a card for the full description.

Nissan Liberty, first generation, factory photo
Factory color shown

1998–2004 Liberty van (first generation)

1998–2004van (5 doors)180.1 in (4,575 mm)

The first generation Nissan Liberty is the only body in the catalog, sold from 1998 to 2004. Its sliding side doors are the main wrap challenge: the door tracks stay bare, and the film is cut along them. The installer trims the edges neatly so the doors open without rubbing the vinyl.

Sliding side doors: the door tracks stay bare, and the film is cut along them.

Film: about 57 ft (17.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 72 ft (22 m).

Roof, hood, chrome delete and PPF on a Liberty

A partial wrap on a Liberty covers the roof, hood, or mirror caps in colour change vinyl. A chrome delete covers the window trim and badges with black film. Paint protection film (PPF) is applied as a clear film on the front end to guard against stone chips.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Nissan Liberty: body, cut-outs and film

A Nissan Liberty vinyl wrap has to handle a van body 180.1 in (4,575 mm) long. The tall sides and large roof area mean more film and more fitting time than on a small hatchback. The five doors and long side panels reward careful planning of panel seams.

Liberty wrap ideas start with the sliding side doors, whose tracks stay bare and guide the film cut. The door handles, badges, and side mirrors need cut-outs or removal for a clean install. The rear wiper and antenna base also come off before film is applied.

To know how much vinyl to wrap a Liberty, count one generation only from 1998 to 2004. No facelift or later body changes alter the amount of film needed. Ordering the full 57 ft (17.5 m) leaves enough for mistakes and the sliding door track cuts.

Questions about wrapping a Nissan Liberty

How much vinyl does it take to wrap a Nissan Liberty?

A full wrap of a Nissan Liberty takes about 57 ft (17.5 m) of 60-inch (1.52 m) cast vinyl film. That figure covers the exterior of the van body including the sliding door cuts. The estimate is for standard colour change film on the first generation model.

Are the sliding doors of a Liberty wrapped?

No, the sliding doors of a Liberty are not wrapped fully. The door tracks stay bare, and the installer cuts the film along them. This keeps the door mechanism working while covering the rest of the door panel.

Can I wrap only the hood or the roof of a Liberty?

Yes, you can wrap only the hood or the roof of a Liberty as a partial wrap. This job uses less film than a full wrap and focuses on one or two panels. Mirror caps are another option for a small colour change.

Is a Liberty hard to wrap?

A Liberty is moderately hard to wrap because of its sliding door tracks and its size of 180.1 in (4,575 mm). The tracks force careful cutting and tucking of the vinyl, while the tall sides need long stretches of film. A van body also has more square footage than a small car.