Wraps by car

Nissan Rogue wrap

The Nissan Rogue wrap page covers all three generations of this compact SUV, from 2007 to the current model. A full vinyl wrap of the newest Rogue body takes about 61 ft (18.5 m) of 60-inch (1.52 m) cast film. The first generation spans 2007–2014, the second 2014–2020, and the third 2020 to now.

3generations18.5 mof film for a full wrap

Nissan Rogue, third generation, factory photo
Nissan Rogue, third generation. Factory color shown.

Nissan Rogue wrap colors and ideas

  • Rogue black wrap
  • Rogue white wrap
  • Rogue gray wrap
  • Rogue silver wrap
  • Rogue red wrap
  • Rogue blue wrap
  • Rogue green wrap
  • Rogue yellow wrap
  • Rogue orange wrap
  • Rogue purple wrap
  • Rogue pink wrap
  • Rogue teal wrap
  • Rogue brown wrap
  • Rogue gold wrap
  • Rogue chrome wrap
  • Rogue color shift wrap
  • Rogue carbon fiber wrap
  • Rogue camo and patterned wrap

How much vinyl to wrap a Nissan Rogue

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
2020–nowSUV (5 doors)183.0 in (4,648 mm)about 61 ft (18.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m)
2014–2020SUV (5 doors)182.3 in (4,630 mm) to 184.5 in (4,686 mm)about 62 ft (19 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 72 ft (22 m)
2007–2014SUV (5 doors)182.9 in (4,645 mm)about 61 ft (18.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m)

Rogue wrap cost factors

Rogue wrap cost is driven by the size of the body, the number of panels, and the extra film needed for a color with a pattern or chrome finish. A second-generation Rogue may use about 62 ft (19 m) of cast film versus 61 ft (18.5 m) on the newest body, and a chrome or patterned design adds roughly 8–10 ft (2.5–3 m) on any generation. Labor also reflects how much trim must be removed around the tailgate and roof.

  • Film for a full wrap: about 61 ft (18.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m).
  • Body: SUV (5 doors).
  • A tailgate with the rear glass in it: the film ends at the edge of the glass.
  • Restyled in 2023: bumpers and lights differ between the versions, and so do the film cuts.

Rogue wraps by generation

Swipe sideways. Tap a card for the full description.

Nissan Rogue, third generation, factory photo
Factory color shown

2020–now Rogue SUV (third generation)

2020–nowSUV (5 doors)183.0 in (4,648 mm)

The third-generation Nissan Rogue was restyled in 2023, and the bumpers and lights changed enough that film cut for one version does not fit the other. An installer must know whether the vehicle is a 2020–2023 or a 2023-and-newer look before cutting the front and rear bumper pieces. The body length stays at 183.0 in (4,648 mm), so the amount of film for a full wrap is unchanged at about 61 ft (18.5 m).

A tailgate with the rear glass in it: the film ends at the edge of the glass.

Film: about 61 ft (18.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m).

Nissan Rogue, second generation, factory photo
Factory color shown

2014–2020 Rogue SUV (second generation)

2014–2020SUV (5 doors)182.3 in (4,630 mm) to 184.5 in (4,686 mm)

The second-generation Nissan Rogue is the longest of the three, measuring from 182.3 in (4,630 mm) to 184.5 in (4,686 mm) after the 2017 restyle. This extra length plus the five-door SUV shape means a full wrap can need about 62 ft (19 m) of cast film or 72 ft (22 m) with chrome or patterned material. The panel count is the same as other generations, but the long roof and large tailgate consume more film per panel.

A tailgate with the rear glass in it: the film ends at the edge of the glass.

Film: about 62 ft (19 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 72 ft (22 m).

Nissan Rogue, first generation, factory photo
Factory color shown

2007–2014 Rogue SUV (first generation)

2007–2014SUV (5 doors)182.9 in (4,645 mm)

Paint age on a first-generation Nissan Rogue built from 2007 to 2014 can vary widely, with some panels original and others repainted. Before a full wrap, an installer should test adhesion on a small spot because aged or repainted clear coat may lift when the film is removed. The body length of 182.9 in (4,645 mm) and the rear glass set into the tailgate are the same challenges as on newer models.

A tailgate with the rear glass in it: the film ends at the edge of the glass.

Film: about 61 ft (18.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m).

Roof, hood, chrome delete and PPF on a Rogue

A Rogue chrome delete covers the window trim and badges with black film, and a partial wrap can be limited to the roof, hood, or mirror caps. Paint protection film (PPF) is a clear wrap usually applied to the front end to guard against stone chips. These smaller jobs reduce material use compared with a full color change wrap and allow a personalized look on one section of the SUV.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film on the front end, also over a wrap.

Wrapping a Nissan Rogue: body, cut-outs and film

A Nissan Rogue vinyl wrap must cover a five-door SUV body with a length between 182.3 in (4,630 mm) and 184.5 in (4,686 mm) depending on the generation. The tall sides and large tailgate add surface area compared with a sedan, yet the panel count is conventional for an SUV. Installers work around four doors, a hood, a roof, and a rear hatch plus the bumpers on every Rogue.

Rogue wrap ideas have to account for the tailgate, where the rear glass sits in the moving metal panel and the film ends at the edge of the glass. Door handles, mirror caps, and badges come off for cleaner edges on every generation. The antenna base and roof rails may need to be loosened or removed before laying film over the roof.

How much vinyl to wrap a Rogue depends on which generation you own because the bodies differ in length and trim. The first-generation model from 2007–2014 needs about 61 ft (18.5 m) of standard cast film or 69 ft (21 m) if you choose chrome or patterned vinyl. The second-generation Rogue from 2014–2020 is the longest and can take 62 ft (19 m) on a plain color wrap, while the current third generation matches the first at 61 ft (18.5 m).

Questions about wrapping a Nissan Rogue

How much vinyl does it take to wrap a Nissan Rogue?

A full vinyl wrap of a Nissan Rogue takes about 61 ft (18.5 m) of 60-inch (1.52 m) cast film for the newest third-generation body. If the design uses chrome or a pattern, plan for about 69 ft (21 m).

Which years of the Rogue take the same film cuts?

The Rogue generations each use different film cuts because the body changed in 2014 and again in 2020, plus a mid-cycle update in 2023 for the third generation. The first generation ran 2007–2014, the second 2014–2020, and the third from 2020 to now, with the 2023 update altering bumper and light shapes.

Can I wrap only the hood or the roof of a Rogue?

Yes, you can wrap only the hood or the roof of a Rogue as a partial job, which also covers mirror caps or a chrome delete on window trim and badges. These smaller areas need far less film than the 61–62 ft (18.5–19 m) used for a complete color change.

Is a Rogue hard to wrap?

A Rogue is not especially hard to wrap, but the rear tailgate adds work because the glass is set into the moving panel and the film must end cleanly at its edge. The SUV's length of 182.3–184.5 in (4,630–4,686 mm) also means more surface to cover than on a smaller car, so an installer spends extra time on the roof and large side panels.