Wraps by car

Nissan Pino wrap

The Nissan Pino wrap page covers one generation of this mini hatchback, produced from 2007 to 2010. A full vinyl wrap of this body takes about 44 ft (13.5 m) of 60-inch (1.52 m) cast film. If you choose chrome or patterned film, plan for about 52 ft (16 m) of material.

1generations13.5 mof film for a full wrap

Nissan Pino, first generation, factory photo
Nissan Pino, first generation. Factory color shown.

Nissan Pino wrap colors and ideas

  • Pino black wrap
  • Pino white wrap
  • Pino gray wrap
  • Pino silver wrap
  • Pino red wrap
  • Pino blue wrap
  • Pino green wrap
  • Pino yellow wrap
  • Pino orange wrap
  • Pino purple wrap
  • Pino pink wrap
  • Pino teal wrap
  • Pino brown wrap
  • Pino gold wrap
  • Pino chrome wrap
  • Pino color shift wrap
  • Pino carbon fiber wrap
  • Pino camo and patterned wrap

How much vinyl to wrap a Nissan Pino

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
2007–2010hatchback (5 doors)133.7 in (3,395 mm)about 44 ft (13.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 52 ft (16 m)

Pino wrap cost factors

Pino wrap cost depends on the size and condition of this 133.7 in (3,395 mm) hatchback, which needs about 44 ft (13.5 m) of 60-inch (1.52 m) cast film. Labor for the tailgate glass cut-out and the five-door jambs adds to the total. If you choose a chrome or patterned film, the material estimate rises to about 52 ft (16 m), which affects the quote.

  • Film for a full wrap: about 44 ft (13.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 52 ft (16 m).
  • Body: hatchback (5 doors).
  • A tailgate with the rear glass in it: the film ends at the edge of the glass.

Pino wraps by generation

Swipe sideways. Tap a card for the full description.

Nissan Pino, first generation, factory photo
Factory color shown

2007–2010 Pino hatchback (first generation)

2007–2010hatchback (5 doors)133.7 in (3,395 mm)

The first generation Nissan Pino was built from 2007 to 2010, and paint age is a key point for a wrap. On a car of these years panels may be original or repainted, and a test spot comes before a full wrap. A small test area on one panel shows whether the film will lift old paint when it is repositioned.

A tailgate with the rear glass in it: the film ends at the edge of the glass.

Film: about 44 ft (13.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 52 ft (16 m).

Roof, hood, chrome delete and PPF on a Pino

A partial wrap on a Nissan Pino can cover the roof, hood, or mirror caps in a different color. A chrome delete wraps the window trim and badges with black film. Paint protection film (PPF) is a clear film that covers the front end from stone chips.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Nissan Pino: body, cut-outs and film

The Nissan Pino vinyl wrap fits a five-door hatchback body that measures 133.7 in (3,395 mm) long. This small size keeps film use modest, and the simple panel layout has no long roof rails or complex bumpers. Because the body is short, an installer can cut most panels from one roll width without splicing.

Pino wrap ideas begin with the tailgate, where the rear glass is set into the panel and film ends at the edge of the glass. The window trim and badges can be covered with black film for a chrome delete. The door handles and mirrors are small parts that can be wrapped in a contrasting color for a detailed finish.

To know how much vinyl to wrap a Pino, you compare only one generation, so the estimate stays stable from 2007 to 2010. The TA0 body code is the same for all years, and the hatchback body has no alternate panel lengths. A full wrap uses about 44 ft (13.5 m) of cast film, while chrome or patterned film adds about 8 ft (2.5 m).

Questions about wrapping a Nissan Pino

How much vinyl does it take to wrap a Nissan Pino?

A full wrap of a Nissan Pino takes about 44 ft (13.5 m) of 60-inch (1.52 m) cast film. For chrome or patterned film the estimate is about 52 ft (16 m).

Can I wrap only the hood or the roof of a Pino?

Yes, you can wrap only the hood or the roof of a Pino. These partial wrap jobs also include mirror caps, while a chrome delete covers window trim and badges, and paint protection film covers the front end.

Is a Pino hard to wrap?

A Pino adds work because the tailgate holds the rear glass, so film must end at the edge of the glass. The car is small at 133.7 in (3,395 mm), but that glass cut-out and the five door jambs take extra time.

How many generations of the Pino does this page cover?

This page covers one generation of the Nissan Pino, from 2007 to 2010.