Porsche 718 Boxster wrap cost depends on the film, the generation, and how much of the car is done. A full wrap of the newest body uses about 46 ft (14 m) of cast film, while a partial job like the hood uses far less. The first generation is shorter, so it needs about 43 ft (13 m) of film. Labor is also set by the convertible body, because the top edge and any sensors require careful finishing.

2016–now Porsche 718 Boxster convertible (fourth generation)
The fourth generation Porsche 718 Boxster has an open top that is not wrapped during a full vinyl job. The fabric roof stays uncovered, and the film ends exactly where the roof begins. If the car has a folding hard top instead, each folding panel is wrapped separately. After that edge, the wrap continues down the doors, fenders, bumpers, and sills without a roof section.
Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.
Some trims have a styling kit on the bumpers and sills: more separate pieces to wrap.
Every trim has parking sensors in the bumpers: the film is cut around each sensor.
Every trim has cameras in the body: the film is cut around each lens.
Film: about 46 ft (14 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 52 ft (16 m).


