Wraps by car

Chevrolet Metro wrap

A Chevrolet Metro wrap changes the look of this small hatchback or sedan with a full vinyl wrap. This page covers the 1998–2001 generation and the film a complete wrap of the newest body takes. The estimate is about 44 ft (13.5 m) for the hatchback to 46 ft (14 m) for the sedan with 60-inch (1.52 m) cast film.

1generations14 mof film for a full wrap

Chevrolet Metro, first generation, factory photo
Chevrolet Metro, first generation. Factory color shown.

Chevrolet Metro wrap colors and ideas

  • Metro black wrap
  • Metro white wrap
  • Metro gray wrap
  • Metro silver wrap
  • Metro red wrap
  • Metro blue wrap
  • Metro green wrap
  • Metro yellow wrap
  • Metro orange wrap
  • Metro purple wrap
  • Metro pink wrap
  • Metro teal wrap
  • Metro brown wrap
  • Metro gold wrap
  • Metro chrome wrap
  • Metro color shift wrap
  • Metro carbon fiber wrap
  • Metro camo and patterned wrap

How much vinyl to wrap a Chevrolet Metro

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1998–2001hatchback, sedan (3 or 4 doors)149.4 in (3,795 mm) to 164.0 in (4,166 mm)about 44 ft (13.5 m) for the hatchback to 46 ft (14 m) for the sedan, 60-inch (1.52 m) cast film; chrome or patterned film: up to about 57 ft (17.5 m)

Metro wrap cost factors

A Metro wrap cost depends on the condition of the paint, the body style and the film chosen. The hatchback needs about 44 ft (13.5 m) and the sedan about 46 ft (14 m) of 60-inch (1.52 m) cast film. Chrome or patterned film can push the amount to about 57 ft (17.5 m) because of repeat matching. Surface prep and the number of door shuts on the 3- or 4-door hatchback also affect the labor.

  • Film for a full wrap: about 44 ft (13.5 m) for the hatchback to 46 ft (14 m) for the sedan, 60-inch (1.52 m) cast film; chrome or patterned film: up to about 57 ft (17.5 m).
  • Body: hatchback, sedan (3 or 4 doors).
  • A tailgate with the rear glass in it: the film ends at the edge of the glass.

Metro wraps by generation

Swipe sideways. Tap a card for the full description.

Chevrolet Metro, first generation, factory photo
Factory color shown

1998–2001 Metro hatchback, sedan (first generation)

1998–2001hatchback, sedan (3 or 4 doors)149.4 in (3,795 mm) to 164.0 in (4,166 mm)

The 1998–2001 Chevrolet Metro comes as a hatchback or sedan, and the body style decides the panel plan and the film amount. The hatchback is a 3- or 4-door with a small tailgate, while the sedan is a 4-door with a separate trunk lid. A full wrap of the hatchback takes about 44 ft (13.5 m) of 60-inch (1.52 m) cast film. The sedan adds about 2 ft (0.5 m) for its longer rear end.

A tailgate with the rear glass in it: the film ends at the edge of the glass.

Film: about 44 ft (13.5 m) for the hatchback to 46 ft (14 m) for the sedan, 60-inch (1.52 m) cast film; chrome or patterned film: up to about 57 ft (17.5 m).

Roof, hood, chrome delete and PPF on a Metro

A partial wrap on a Chevrolet Metro can cover the roof, hood or mirror caps. A Metro chrome delete covers the window trim and badges with black film to replace the bright finish. Paint protection film (PPF) is a clear film applied to the front end to guard against stone chips. These smaller jobs give a visible change without a full vehicle wrap.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Chevrolet Metro: body, cut-outs and film

A Chevrolet Metro vinyl wrap uses the car's small hatchback and sedan body styles to keep material needs low. The hatchback is the shortest at 149.4 in (3,795 mm), while the sedan reaches 164.0 in (4,166 mm), so a wrap plan follows those sizes. Panel count is modest and most surfaces are flat, which helps film lay down evenly. A 60-inch (1.52 m) cast film handles the roof and hood without seams.

For a clean Metro wrap, the tailgate with the rear glass in it means the film ends at the edge of the glass. The installer masks the glass and cuts the film to the rubber seal for a neat line. The door handles, mirrors and badges are removed to wrap behind them, and the front bumper comes off for access to the lower edge.

When counting how much vinyl to wrap a Metro, the body style changes the amount between the hatchback and sedan. The hatchback takes about 44 ft (13.5 m) of cast film, while the sedan takes about 46 ft (14 m). A chrome or patterned film adds material for alignment and waste, up to about 57 ft (17.5 m). The single generation from 1998–2001 keeps the panel design consistent across production years.

Questions about wrapping a Chevrolet Metro

How much vinyl does it take to wrap a Chevrolet Metro?

A Chevrolet Metro takes about 44 to 46 ft (13.5 to 14 m) of vinyl for a full wrap. The hatchback needs about 44 ft (13.5 m) and the sedan about 46 ft (14 m) using 60-inch (1.52 m) cast film. A chrome or patterned film can raise the total to about 57 ft (17.5 m).

Which Metro body takes more film?

The sedan takes more film than the hatchback. The sedan wrap estimate is about 46 ft (14 m) of 60-inch (1.52 m) cast film, while the hatchback is about 44 ft (13.5 m). The sedan's longer body and separate trunk lid add the extra material.

Can I wrap only the hood or the roof of a Metro?

Yes, you can wrap only the hood or the roof of a Metro. A partial wrap covers the roof, hood or mirror caps as separate jobs. This is a good way to change one area without wrapping the whole car.

Is a Metro hard to wrap?

A Metro is not hard to wrap, but the tailgate with the rear glass in it adds a precise cut. The installer must cut the film cleanly at the edge of the glass, which takes extra time. The car's small size and flat panels make the rest of the job straightforward.