Wraps by car

Opel GT wrap

The Opel GT is a two-seat sports car sold across two generations, from 1968 to 1973 and from 2006 to 2009. The newest body wears a full vinyl wrap in about 44 ft (13.5 m) of 60-inch (1.52 m) cast film. Chrome or patterned film adds roughly 5 ft (1.5 m) to the total.

2generations13.5 mof film for a full wrap

Opel GT, second generation, factory photo
Opel GT, second generation. Factory color shown.

Opel GT wrap colors and ideas

  • Opel GT black wrap
  • Opel GT white wrap
  • Opel GT gray wrap
  • Opel GT silver wrap
  • Opel GT red wrap
  • Opel GT blue wrap
  • Opel GT green wrap
  • Opel GT yellow wrap
  • Opel GT orange wrap
  • Opel GT purple wrap
  • Opel GT pink wrap
  • Opel GT teal wrap
  • Opel GT brown wrap
  • Opel GT gold wrap
  • Opel GT chrome wrap
  • Opel GT color shift wrap
  • Opel GT carbon fiber wrap
  • Opel GT camo and patterned wrap

How much vinyl to wrap an Opel GT

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
2006–2009convertible (2 doors)161.4 in (4,100 mm)about 44 ft (13.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 49 ft (15 m)
1968–1973coupe (2 doors)161.9 in (4,113 mm)about 44 ft (13.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 49 ft (15 m)

Opel GT wrap cost factors

An Opel GT wrap cost depends on the film chosen, the body condition, and the work in the doors and roof. Cast film for this car runs about 44 ft (13.5 m), or 49 ft (15 m) with chrome or patterned film. A first-generation car may need more preparation time if the paint is original and worn.

  • Film for a full wrap: about 44 ft (13.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 49 ft (15 m).
  • Body: convertible (2 doors).
  • Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

Opel GT wraps by generation

Swipe sideways. Tap a card for the full description.

Opel GT, second generation, factory photo
Factory color shown

2006–2009 Opel GT convertible (second generation)

2006–2009convertible (2 doors)161.4 in (4,100 mm)

The second-generation Opel GT is a convertible, so a wrap stops where a fabric top begins. A folding hard top is wrapped as panels of its own, but the fabric version stays uncovered. Film edges along the roof opening are tucked and sealed to keep them clean.

Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

Film: about 44 ft (13.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 49 ft (15 m).

Opel GT, first generation, factory photo
Factory color shown

1968–1973 Opel GT coupe (first generation)

1968–1973coupe (2 doors)161.9 in (4,113 mm)

First-generation Opel GT paint can be original or repainted after 1968–1973 production. A test spot before a full wrap shows whether the film will lift old paint or stick to a respray. Panels with failing clear coat need sanding and primer before any film goes on.

Two long side doors: each door is one large piece of film.

Film: about 44 ft (13.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 49 ft (15 m).

Roof, hood, chrome delete and PPF on an Opel GT

A partial wrap on the Opel GT covers the hood, mirror caps, or rear deck without wrapping the whole body. Chrome delete for this car is the window trim and badges covered in black film. Paint protection film, or PPF, is applied as clear film on the front end to guard against stone chips.

  • Partial wrap: hood, mirror caps, rear deck.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping an Opel GT: body, cut-outs and film

An Opel GT vinyl wrap covers a compact body, either a 1968–1973 coupe at 161.9 in (4,113 mm) or a 2006–2009 convertible at 161.4 in (4,100 mm). Both styles have two doors, so film use stays close to 44 ft (13.5 m) on every body. The side panels are shorter than on a sedan, but the rear quarters still need careful trimming around the wheel arches.

Opel GT wrap ideas start with the two long side doors, each one a single large piece of film on the first generation. The second generation's folded roof is wrapped as separate panels, while a fabric top is left uncovered. Badges and window trim come off for a clean chrome delete, which is bright trim covered with black film.

The answer to how much vinyl to wrap an Opel GT stays the same for both generations: about 44 ft (13.5 m) of 60-inch (1.52 m) cast film. A chrome or patterned film needs roughly 49 ft (15 m) because the pattern must be matched. Wrapping the first-generation coupe takes no extra film for the roof, since it is already part of the body.

Questions about wrapping an Opel GT

How much vinyl does it take to wrap an Opel GT?

It takes about 44 ft (13.5 m) of 60-inch (1.52 m) cast film to wrap an Opel GT. The 2006–2009 convertible body needs that amount, and the 1968–1973 coupe is nearly the same size. If you choose chrome or patterned film, plan for about 49 ft (15 m).

Is the top of an Opel GT wrapped?

No, a fabric top on the Opel GT convertible is not wrapped. The film ends where the fabric begins, and a folding hard top is wrapped as its own panels. The coupe roof on the first generation is part of the full vinyl wrap.

Can I wrap only the hood or the roof of an Opel GT?

Yes, you can wrap only the hood or the rear deck of an Opel GT as a partial wrap. Mirror caps are another small job that changes the look without covering the whole body. A chrome delete on the window trim and badges is also done separately.

Is an Opel GT hard to wrap?

The Opel GT has long doors that each take one large piece of film, and that adds some work. The 161.4 in (4,100 mm) convertible body also requires careful finishing where the film meets the top. On the 1968–1973 car, original paint may need test spots before a full wrap.