Wraps by car

Buick GS wrap

The Buick GS wrap page covers the first-generation 1970–1972 sports car, offered as a convertible and a two-door coupe. A full vinyl wrap of this body takes about 54 ft (16.5 m) for the convertible to 56 ft (17 m) for the coupe using 60-inch (1.52 m) cast film. Chrome or patterned film increases the estimate to up to about 72 ft (22 m) because of extra material handling. The catalog lists one generation, so the sizing stays consistent across the production run.

1generations16.5 mof film for a full wrap

Buick GS, first generation, factory photo
Buick GS, first generation. Factory color shown.

Buick GS wrap colors and ideas

  • Buick GS black wrap
  • Buick GS white wrap
  • Buick GS gray wrap
  • Buick GS silver wrap
  • Buick GS red wrap
  • Buick GS blue wrap
  • Buick GS green wrap
  • Buick GS yellow wrap
  • Buick GS orange wrap
  • Buick GS purple wrap
  • Buick GS pink wrap
  • Buick GS teal wrap
  • Buick GS brown wrap
  • Buick GS gold wrap
  • Buick GS chrome wrap
  • Buick GS color shift wrap
  • Buick GS carbon fiber wrap
  • Buick GS camo and patterned wrap

How much vinyl to wrap a Buick GS

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1970–1972convertible, coupe (2 doors)202.0 in (5,131 mm)about 54 ft (16.5 m) for the convertible to 56 ft (17 m) for the coupe, 60-inch (1.52 m) cast film; chrome or patterned film: up to about 72 ft (22 m)

Buick GS wrap cost factors

Buick GS wrap cost depends on the surface area of the 202.0 in (5,131 mm) body, which sets the amount of film needed. The coupe requires a little more material than the convertible, so its material component is slightly higher. Chrome or patterned film uses up to about 72 ft (22 m), which adds waste compared with a standard 54–56 ft (16.5–17 m) solid color roll. Labor time for the long doors and any cut-outs around handles and badges is the other main cost driver.

  • Film for a full wrap: about 54 ft (16.5 m) for the convertible to 56 ft (17 m) for the coupe, 60-inch (1.52 m) cast film; chrome or patterned film: up to about 72 ft (22 m).
  • Body: convertible, coupe (2 doors).
  • Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.
  • Two long side doors: each door is one large piece of film.

Buick GS wraps by generation

Swipe sideways. Tap a card for the full description.

Buick GS, first generation, factory photo
Factory color shown

1970–1972 Buick GS convertible, coupe (first generation)

1970–1972convertible, coupe (2 doors)202.0 in (5,131 mm)

The first-generation Buick GS convertible has a fabric top that is left uncovered, and the vinyl wrap ends where the top begins at the body line. The film is cut cleanly along the edge of the soft top, so no part of the fabric is touched by adhesive. If the car has a folding hard top, that roof is wrapped as separate panels that move with the mechanism. The rest of the body, including the two long doors, wraps normally up to that boundary.

Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

Two long side doors: each door is one large piece of film.

Film: about 54 ft (16.5 m) for the convertible to 56 ft (17 m) for the coupe, 60-inch (1.52 m) cast film; chrome or patterned film: up to about 72 ft (22 m).

Roof, hood, chrome delete and PPF on a Buick GS

Partial wrap on a Buick GS covers the roof, hood or mirror caps without wrapping the whole car. Chrome delete replaces the bright window trim and badges with black film for a darker look. Paint protection film (PPF) is a clear layer applied to the front end only. The convertible roof can be partially wrapped only if it is a hard top; the fabric top is not wrapped at all.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Buick GS: body, cut-outs and film

The Buick GS vinyl wrap uses a long 202.0 in (5,131 mm) body with two large side doors that each take one big piece of film. The coupe needs slightly more film than the convertible because the fixed roof adds surface area that the open top does not have. A 60-inch (1.52 m) roll covers the width of most panels in one pass, which reduces seams. The length of the car is a key measurement for estimating film on the hood, trunk and sides.

Buick GS wrap ideas must account for the fabric top on the convertible, which is not wrapped and the film ends where it begins. A folding hard top, if fitted, is wrapped as its own set of panels rather than as one roof area. The two long side doors are each wrapped as one large piece of film, so a skilled installer can avoid visible joins. Cut-outs are needed around door handles, locks and any badges that stay on the car.

How much vinyl to wrap a Buick GS stays the same across the single generation because the body dimensions do not change from 1970 to 1972. The coupe and convertible differ only in the roof, which moves the material estimate between 56 ft (17 m) and 54 ft (16.5 m). A partial job like the hood alone needs far less film than a full body color change. Film choice changes the total only when chrome or patterned film is ordered, pushing the amount to about 72 ft (22 m).

Questions about wrapping a Buick GS

How much vinyl does it take to wrap a Buick GS?

A Buick GS wrap takes about 54 ft (16.5 m) for the convertible to 56 ft (17 m) for the coupe using 60-inch (1.52 m) cast film. Chrome or patterned film raises the requirement to up to about 72 ft (22 m). The figure covers the full body of the first-generation 1970–1972 car. The coupe sits at the higher end because of its fixed roof.

Is the top of a Buick GS wrapped?

The fabric top of a Buick GS convertible is not wrapped. The vinyl film ends where the top begins, so no material is applied to the soft top. A folding hard top, if the car has one, is wrapped as its own panels. The rest of the body receives film as normal.

Which Buick GS body takes more film?

The Buick GS coupe takes more film than the convertible because the fixed roof adds surface area. The coupe needs about 56 ft (17 m), while the convertible needs about 54 ft (16.5 m) with 60-inch (1.52 m) cast film. The difference comes only from the roof, as the rest of the body is identical. Both estimates use the same roll width and material type.

Can I wrap only the hood or the roof of a Buick GS?

Only the hood or the roof of a Buick GS can be wrapped as a partial job without covering the whole car. Mirror caps are another smaller area that can be done alone. The roof is wrapped only if it is a metal or hard panel, not the fabric convertible top. A partial wrap uses less film than a full body color change.