Wraps by car

Buick Skyhawk wrap

The Buick Skyhawk wrap page covers the first generation of this car, produced from 1974 to 1980. A full vinyl wrap of the hatchback body takes about 49 ft (15 m) of 60-inch (1.52 m) cast film. If you choose a chrome or patterned film, plan for about 59 ft (18 m). This page explains the layout, the film estimate and the work steps for this model.

1generations15 mof film for a full wrap

Buick Skyhawk, first generation, factory photo
Buick Skyhawk, first generation. Factory color shown.

Buick Skyhawk wrap colors and ideas

  • Skyhawk black wrap
  • Skyhawk white wrap
  • Skyhawk gray wrap
  • Skyhawk silver wrap
  • Skyhawk red wrap
  • Skyhawk blue wrap
  • Skyhawk green wrap
  • Skyhawk yellow wrap
  • Skyhawk orange wrap
  • Skyhawk purple wrap
  • Skyhawk pink wrap
  • Skyhawk teal wrap
  • Skyhawk brown wrap
  • Skyhawk gold wrap
  • Skyhawk chrome wrap
  • Skyhawk color shift wrap
  • Skyhawk carbon fiber wrap
  • Skyhawk camo and patterned wrap

How much vinyl to wrap a Buick Skyhawk

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1974–1980hatchback (3 doors)179.3 in (4,555 mm)about 49 ft (15 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 59 ft (18 m)

Skyhawk wrap cost factors

Skyhawk wrap cost depends on the amount of film, the film type and the prep work on this car. A full wrap takes about 49 ft (15 m) of 60-inch (1.52 m) cast film, or about 59 ft (18 m) for chrome or patterned film. The doors and tailgate require careful trimming, which adds labor time to the job. The final cost also reflects the condition of the paint and how many small parts are removed before the wrap.

  • Film for a full wrap: about 49 ft (15 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 59 ft (18 m).
  • Body: hatchback (3 doors).
  • A tailgate with the rear glass in it: the film ends at the edge of the glass.
  • Two long side doors: each door is one large piece of film.

Skyhawk wraps by generation

Swipe sideways. Tap a card for the full description.

Buick Skyhawk, first generation, factory photo
Factory color shown

1974–1980 Skyhawk hatchback (first generation)

1974–1980hatchback (3 doors)179.3 in (4,555 mm)

The first generation Buick Skyhawk, built from 1974 to 1980, often has original or repainted panels because of the car's age. A wrap installer checks the paint with a test spot before the full wrap is applied. The test shows whether the film will stick evenly and come off without lifting the old paint. This step is part of the estimate for a car of these years.

A tailgate with the rear glass in it: the film ends at the edge of the glass.

Two long side doors: each door is one large piece of film.

Film: about 49 ft (15 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 59 ft (18 m).

Roof, hood, chrome delete and PPF on a Skyhawk

A partial wrap on a Skyhawk covers the roof, the hood or the mirror caps. A chrome delete wraps the window trim and badges with black film, which changes the bright parts of the car. Paint protection film (PPF) is a clear film that can be applied to the front end to protect it from stone chips. These jobs use less film than a full wrap and are planned around the same hatchback layout.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film on the front end, also over a wrap.

Wrapping a Buick Skyhawk: body, cut-outs and film

A Buick Skyhawk vinyl wrap follows the shape of its single body style, a three-door hatchback that is 179.3 in (4,555 mm) long. The tailgate carries the rear glass, so the film must end cleanly at the edge of the glass and leaves less metal to cover on that panel. The two long side doors each take one large piece of film, which keeps the visible seams low. A full wrap on this body works with the standard cast film length of about 49 ft (15 m).

Skyhawk wrap ideas include two details that shape the layout. The tailgate has the rear glass built into it, so the installer trims the film to the edge of the glass and does not wrap the glass itself. The side doors are long enough that each door is covered with one large piece of film rather than patched sections. For a clean result, the door handles and mirrors are removed before the film is laid down. Chrome or patterned film adds about 10 ft (3 m) to the total estimate.

To know how much vinyl to wrap a Skyhawk, you count only one generation because the catalog covers the 1974–1980 hatchback. The base estimate is about 49 ft (15 m) of 60-inch (1.52 m) cast film for a full color change wrap. A chrome or patterned film needs about 59 ft (18 m) because the pattern must be matched across the panels. The tailgate and the long doors do not change the total length, but they affect how the film is cut.

Questions about wrapping a Buick Skyhawk

How much vinyl does it take to wrap a Buick Skyhawk?

A full wrap of a Buick Skyhawk takes about 49 ft (15 m) of 60-inch (1.52 m) cast film. For chrome or patterned film, the estimate rises to about 59 ft (18 m). These figures cover the full hatchback body of the first generation.

Can I wrap only the hood or the roof of a Skyhawk?

Yes, you can wrap only the hood or the roof of a Skyhawk. A partial wrap can also cover the mirror caps, and a chrome delete covers the window trim and badges. Clear paint protection film can be applied to the front end without wrapping the whole car.

Is a Skyhawk hard to wrap?

A Skyhawk is not hard to wrap, but two parts add work. The tailgate has the rear glass in it, so the film must be trimmed exactly along the edge of the glass. The two long side doors are covered with one large piece of film each, which takes care in handling and positioning.

How many generations of the Skyhawk does this page cover?

This page covers one generation of the Skyhawk, the first generation from 1974 to 1980. All film estimates on this page refer to that hatchback body.