Wraps by car

Ford Custom wrap

The Ford Custom wrap page covers the first generation coupe produced from 1949 to 1955. A full vinyl wrap of this body uses about 61 ft (18.5 m) of 60-inch (1.52 m) cast film. With chrome or patterned film the estimate rises to about 69 ft (21 m).

1generations18.5 mof film for a full wrap

Ford Custom, first generation, factory photo
Ford Custom, first generation. Factory color shown.

Ford Custom wrap colors and ideas

  • Custom black wrap
  • Custom white wrap
  • Custom gray wrap
  • Custom silver wrap
  • Custom red wrap
  • Custom blue wrap
  • Custom green wrap
  • Custom yellow wrap
  • Custom orange wrap
  • Custom purple wrap
  • Custom pink wrap
  • Custom teal wrap
  • Custom brown wrap
  • Custom gold wrap
  • Custom chrome wrap
  • Custom color shift wrap
  • Custom carbon fiber wrap
  • Custom camo and patterned wrap

How much vinyl to wrap a Ford Custom

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1949–1955coupe (2 doors)196.7 in (4,996 mm)about 61 ft (18.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m)

Custom wrap cost factors

Custom wrap cost follows three things: the size of the coupe at 196.7 in (4,996 mm), the film you pick and the prep work on old paint. A chrome or patterned film uses about 69 ft (21 m) instead of 61 ft (18.5 m). Removing trim and filling chips adds labor before the wrap starts.

  • Film for a full wrap: about 61 ft (18.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m).
  • Body: coupe (2 doors).
  • Two long side doors: each door is one large piece of film.

Custom wraps by generation

Swipe sideways. Tap a card for the full description.

Ford Custom, first generation, factory photo
Factory color shown

1949–1955 Custom coupe (first generation)

1949–1955coupe (2 doors)196.7 in (4,996 mm)

The first generation Custom ran from 1949 to 1955 as a two-door coupe, and paint age decides how the wrap is installed. Panels on these cars may be original or repainted, so a test spot of film is applied before the full wrap. The test shows whether the film will lift or pull loose paint when it is removed.

Two long side doors: each door is one large piece of film.

Film: about 61 ft (18.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m).

Roof, hood, chrome delete and PPF on a Custom

A partial wrap on a Custom is a practical way to change the roof, hood or mirror caps without covering the whole coupe. A Custom chrome delete covers the window trim and badges with black film. Paint protection film (PPF) in clear film shields the front end from stone chips.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Ford Custom: body, cut-outs and film

A Ford Custom vinyl wrap is planned around one body style, a two-door coupe with a length of 196.7 in (4,996 mm). The long doors and roof make the visible surface larger than the footprint suggests. Installers count the rocker panels and the rear fender skirts when ordering film.

Custom wrap ideas often start with the two long side doors because each door is one large piece of film. The door handles, locks and beltline trim need cut-outs or removal before the panel is laid. The front grille and bumper come off for a clean edge on the nose.

How much vinyl to wrap a Custom depends on the paint and trim under the film, not on a long list of body versions. The only generation in this catalog is the 1949–1955 coupe, so the same 61 ft (18.5 m) estimate applies to every year. A car with added chrome or a patterned film needs about 69 ft (21 m).

Questions about wrapping a Ford Custom

How much vinyl does it take to wrap a Ford Custom?

A full wrap of a Ford Custom takes about 61 ft (18.5 m) of 60-inch (1.52 m) cast vinyl. If you choose chrome or patterned film, the estimate is about 69 ft (21 m). These figures cover the 1949–1955 two-door coupe.

Can I wrap only the hood or the roof of a Custom?

Yes, you can wrap only the hood or the roof of a Custom. Partial wrap jobs on this car also include the mirror caps. Hood and roof wraps use less film than a full 61 ft (18.5 m) wrap.

Is a Custom hard to wrap?

A Custom is not hard to wrap, but its two long side doors and 196.7 in (4,996 mm) length add work. Each door is one large piece of film that needs a steady hand. Old paint on 1949–1955 cars means a test spot is needed first.

How many generations of the Custom does this page cover?

This page covers one generation of the Ford Custom, the first generation from 1949 to 1955. It is the only generation in the catalog. The body style is a two-door coupe.