Wraps by car

Ford S-MAX wrap

The Ford S-MAX wrap guide covers both generations of this minivan and the vinyl wrap a full wrap of the newest body takes. A complete color change on a 2015 or newer S-MAX uses about 57 ft (17.5 m) of 60-inch (1.52 m) cast film. Chrome or patterned film increases the amount to about 69 ft (21 m) because of the extra material needed for pattern matching.

2generations17.5 mof film for a full wrap

Ford S-MAX, second generation, factory photo
Ford S-MAX, second generation. Factory color shown.

Ford S-MAX wrap colors and ideas

  • S-MAX black wrap
  • S-MAX white wrap
  • S-MAX gray wrap
  • S-MAX silver wrap
  • S-MAX red wrap
  • S-MAX blue wrap
  • S-MAX green wrap
  • S-MAX yellow wrap
  • S-MAX orange wrap
  • S-MAX purple wrap
  • S-MAX pink wrap
  • S-MAX teal wrap
  • S-MAX brown wrap
  • S-MAX gold wrap
  • S-MAX chrome wrap
  • S-MAX color shift wrap
  • S-MAX carbon fiber wrap
  • S-MAX camo and patterned wrap

How much vinyl to wrap a Ford S-MAX

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
2015–nowvan (5 doors)188.8 in (4,796 mm) to 189.1 in (4,804 mm)about 57 ft (17.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m)
2006–2015van (5 doors)187.7 in (4,768 mm) to 187.9 in (4,772 mm)about 69 ft (21 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 82 ft (25 m)

S-MAX wrap cost factors

S-MAX wrap cost is driven by the amount of film, the body size, and the labor for the sliding doors and roof rails. A second generation S-MAX needs about 57 ft (17.5 m) of film for a full wrap, while the first generation needs about 69 ft (21 m). Chrome delete or patterned film increases the material to about 69 ft (21 m) on the second generation and about 82 ft (25 m) on the first generation. The installer's time also changes with the cut-outs around fog lamps and parking sensors on some trims.

  • Film for a full wrap: about 57 ft (17.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m).
  • Body: van (5 doors).
  • Sliding side doors: the door tracks stay bare, and the film is cut along them.
  • Every trim has a panoramic glass roof: glass is not wrapped, and the film ends at the roof rails.
  • Every trim has fog lamps in the front bumper: cut-outs in the bumper film.
  • Restyled in 2019: bumpers and lights differ between the versions, and so do the film cuts.

S-MAX wraps by generation

Swipe sideways. Tap a card for the full description.

Ford S-MAX, second generation, factory photo
Factory color shown

2015–now S-MAX van (second generation)

2015–nowvan (5 doors)188.8 in (4,796 mm) to 189.1 in (4,804 mm)

The second generation Ford S-MAX has sliding side doors whose tracks stay bare and decide where the film is cut. The film is trimmed along the track channel so that the door can open and close without rubbing. Installers leave a small margin around the track to prevent peeling, and the track itself remains the original paint color. This detail is the same on every trim of this generation, including the restyled 2019 models.

Sliding side doors: the door tracks stay bare, and the film is cut along them.

Every trim has a panoramic glass roof: glass is not wrapped, and the film ends at the roof rails.

Every trim has fog lamps in the front bumper: cut-outs in the bumper film.

Film: about 57 ft (17.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m).

Ford S-MAX, first generation, factory photo
Factory color shown

2006–2015 S-MAX van (first generation)

2006–2015van (5 doors)187.7 in (4,768 mm) to 187.9 in (4,772 mm)

The first generation Ford S-MAX from 2006 to 2015 may have original or repainted panels because of paint age, and a test spot comes before a full wrap. Installers check the paint condition on a small area to see if the film will adhere properly. If the paint is failing, the film may lift or damage the paint when removed. The restyle in 2010 did not affect the body panels, so the same caution applies to all years of this generation.

Sliding side doors: the door tracks stay bare, and the film is cut along them.

Some trims have a panoramic glass roof: glass is not wrapped, and the film ends at the roof rails.

Some trims have bright decorative moldings: they stay bright next to the film unless a chrome delete covers them.

Some trims have parking sensors in the bumpers: the film is cut around each sensor.

Every trim has fog lamps in the front bumper: cut-outs in the bumper film.

Film: about 69 ft (21 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 82 ft (25 m).

Roof, hood, chrome delete and PPF on an S-MAX

S-MAX chrome delete and partial wrap jobs cover smaller areas than a full color change. A partial wrap can include the hood, mirror caps, and trunk lid, which gives a two-tone look without wrapping the whole van. Chrome delete replaces bright window trim and badges with black film. Paint protection film (PPF) is a clear film on the front end that guards against stone chips.

  • Partial wrap: hood, mirror caps, trunk lid.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film on the front end, also over a wrap.

Wrapping a Ford S-MAX: body, cut-outs and film

The Ford S-MAX vinyl wrap is shaped by its van body with five doors and a length of 188.8 in (4,796 mm) to 189.1 in (4,804 mm) on the second generation. The tall sides and long roof add surface area compared with a sedan, so a full wrap uses more film. The sliding side doors are the largest single panels and require careful planning around their tracks. The first generation is slightly shorter at 187.7 in (4,768 mm) to 187.9 in (4,772 mm), which changes the film estimate slightly.

S-MAX wrap ideas should account for the sliding door tracks, the panoramic glass roof, and the fog lamps in the front bumper. On every trim the door tracks stay bare and the film is cut along them, so the film does not interfere with the door movement. The glass roof is not wrapped, and the film ends at the roof rails on every trim of the second generation. Cut-outs in the bumper film keep the fog lamps clear on both generations.

How much vinyl to wrap an S-MAX depends mainly on the generation and the type of film chosen. The second generation from 2015 onward takes about 57 ft (17.5 m) of standard cast film, while the first generation from 2006 to 2015 takes about 69 ft (21 m). Chrome or patterned film adds roughly 20 percent because the installer must align patterns across panels. A restyle in 2019 did not change the body dimensions enough to alter the film estimate for the second generation.

Questions about wrapping a Ford S-MAX

How much vinyl does it take to wrap a Ford S-MAX?

It takes about 57 ft (17.5 m) of 60-inch (1.52 m) cast film to fully wrap the newest Ford S-MAX body, which is the second generation from 2015 onward. This estimate is for a standard color change wrap. Chrome or patterned film requires about 69 ft (21 m) because the pattern must be matched across panels.

Are the sliding doors of an S-MAX wrapped?

Yes, the sliding doors of an S-MAX are wrapped, but the door tracks stay bare and the film is cut along them. The track area cannot be covered because the door mechanism needs clearance. The film is trimmed neatly around the track so the wrap looks clean and the doors operate normally.

Can the roof of an S-MAX be wrapped?

Yes, the roof of an S-MAX can be wrapped, but the panoramic glass roof on every trim of the second generation is not wrapped. The film ends at the roof rails, leaving the glass uncovered. On the first generation, some trims have a panoramic glass roof and the same rule applies.

Which years of the S-MAX take the same film cuts?

The same film cuts apply within each generation of the S-MAX: the second generation runs from 2015 to now and was restyled in 2019 without changing the body, while the first generation runs from 2006 to 2015 and was restyled in 2010. The sliding door tracks and bumper cut-outs are the same for all years of a given generation.