Wraps by car

Ferrari 512 M wrap

The Ferrari 512 M wrap page covers the single first-generation coupe produced from 1994 to 1996. A full vinyl wrap of this sports car takes about 46 ft (14 m) of 60-inch (1.52 m) cast film. Chrome or patterned film raises the estimate to about 57 ft (17.5 m).

1generations14 mof film for a full wrap

Ferrari 512 M, first generation, factory photo
Ferrari 512 M, first generation. Factory color shown.

Ferrari 512 M wrap colors and ideas

  • Ferrari 512 M black wrap
  • Ferrari 512 M white wrap
  • Ferrari 512 M gray wrap
  • Ferrari 512 M silver wrap
  • Ferrari 512 M red wrap
  • Ferrari 512 M blue wrap
  • Ferrari 512 M green wrap
  • Ferrari 512 M yellow wrap
  • Ferrari 512 M orange wrap
  • Ferrari 512 M purple wrap
  • Ferrari 512 M pink wrap
  • Ferrari 512 M teal wrap
  • Ferrari 512 M brown wrap
  • Ferrari 512 M gold wrap
  • Ferrari 512 M chrome wrap
  • Ferrari 512 M color shift wrap
  • Ferrari 512 M carbon fiber wrap
  • Ferrari 512 M camo and patterned wrap

How much vinyl to wrap a Ferrari 512 M

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1994–1996coupe (2 doors)176.4 in (4,480 mm)about 46 ft (14 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 57 ft (17.5 m)

Ferrari 512 M wrap cost factors

A Ferrari 512 M wrap cost is driven by the car's single coupe body and its 176.4 in (4,480 mm) length, which sets the film area at about 46 ft (14 m). The choice of cast film with a chrome or patterned finish raises the material amount to about 57 ft (17.5 m). Labor changes with how much disassembly the installer does on the bumpers, mirrors, and door handles.

  • Film for a full wrap: about 46 ft (14 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 57 ft (17.5 m).
  • Body: coupe (2 doors).
  • Two long side doors: each door is one large piece of film.

Ferrari 512 M wraps by generation

Swipe sideways. Tap a card for the full description.

Ferrari 512 M, first generation, factory photo
Factory color shown

1994–1996 Ferrari 512 M coupe (first generation)

1994–1996coupe (2 doors)176.4 in (4,480 mm)

The first generation Ferrari 512 M was produced from 1994 to 1996 as a two-door coupe. Paint age matters on this car because panels may be original or repainted, and a test spot comes before a full wrap to check adhesion. Its body length of 176.4 in (4,480 mm) and the large door pieces set the film estimate at about 46 ft (14 m) of 60-inch cast film.

Two long side doors: each door is one large piece of film.

Film: about 46 ft (14 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 57 ft (17.5 m).

Roof, hood, chrome delete and PPF on a Ferrari 512 M

Partial wrap options for a Ferrari 512 M include the roof, hood, and mirror caps as smaller color-change areas. A chrome delete covers the window trim and badges with black film to change the brightwork. Paint protection film (PPF) is a clear film applied to the front end to guard against stone chips.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Ferrari 512 M: body, cut-outs and film

A Ferrari 512 M vinyl wrap is shaped by the coupe's two long side doors and its 176.4 in (4,480 mm) length. The doors are large enough that each one is wrapped as one piece, which reduces seams but demands precise squeegee work. The low roofline and wide rear haunches call for careful film positioning to avoid overstretching.

Ferrari 512 M wrap ideas start with the two side doors, which are each one large piece of film and form the main visual field. The front bumper, side mirrors, and door handles need cut-outs or removal for a clean install. The rear bumper and tail light surrounds also benefit from taking parts off the car before film is applied.

How much vinyl to wrap a Ferrari 512 M depends on the one generation this page covers, built from 1994 to 1996. There are no earlier or later body styles to compare, so film counts stay consistent across these years. The estimate of about 46 ft (14 m) of 60-inch film applies to the coupe body without changes between production years.

Questions about wrapping a Ferrari 512 M

How much vinyl does it take to wrap a Ferrari 512 M?

It takes about 46 ft (14 m) of 60-inch (1.52 m) cast film to wrap a Ferrari 512 M. Chrome or patterned film raises that to about 57 ft (17.5 m) for the same coupe body.

Can I wrap only the hood or the roof of a Ferrari 512 M?

Yes, you can wrap only the hood or the roof of a Ferrari 512 M. These partial wrap areas are offered along with mirror caps for smaller jobs on this car.

Is a Ferrari 512 M hard to wrap?

Yes, a Ferrari 512 M adds work because the two long side doors are each one large piece of film, and the car is 176.4 in (4,480 mm) long. The single-piece doors demand careful stretching and positioning to avoid wrinkles and overstretching the cast vinyl.

How many generations of the Ferrari 512 M does this page cover?

This page covers one generation of the Ferrari 512 M, the first generation produced from 1994 to 1996. It is a two-door coupe with a length of 176.4 in (4,480 mm).