Wraps by car

Ferrari FXX K wrap

The Ferrari FXX K wrap page covers this one-generation track-focused sports car, produced from 2015 to 2017. A full vinyl wrap of its open-top body takes about 46 ft (14 m) of 60-inch (1.52 m) cast film. Chrome or patterned film raises the estimate to about 54 ft (16.5 m) because of extra material needed for alignment.

1generations14 mof film for a full wrap

Ferrari FXX K, first generation, factory photo
Ferrari FXX K, first generation. Factory color shown.

Ferrari FXX K wrap colors and ideas

  • FXX K black wrap
  • FXX K white wrap
  • FXX K gray wrap
  • FXX K silver wrap
  • FXX K red wrap
  • FXX K blue wrap
  • FXX K green wrap
  • FXX K yellow wrap
  • FXX K orange wrap
  • FXX K purple wrap
  • FXX K pink wrap
  • FXX K teal wrap
  • FXX K brown wrap
  • FXX K gold wrap
  • FXX K chrome wrap
  • FXX K color shift wrap
  • FXX K carbon fiber wrap
  • FXX K camo and patterned wrap

How much vinyl to wrap a Ferrari FXX K

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
2015–2017convertible (2 doors)192.8 in (4,896 mm)about 46 ft (14 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 54 ft (16.5 m)

FXX K wrap cost factors

FXX K wrap cost depends mainly on the size of the body, which at 192.8 in (4,896 mm) is long for a sports car and needs more film. The film type matters: chrome or patterned film comes in at about 54 ft (16.5 m), against about 46 ft (14 m) for standard cast film. Labor is also higher because the open top and sharp body lines require careful cutting and trimming around openings. A partial job or a chrome delete will reduce material and time.

  • Film for a full wrap: about 46 ft (14 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 54 ft (16.5 m).
  • Body: convertible (2 doors).
  • Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

FXX K wraps by generation

Swipe sideways. Tap a card for the full description.

Ferrari FXX K, first generation, factory photo
Factory color shown

2015–2017 FXX K convertible (first generation)

2015–2017convertible (2 doors)192.8 in (4,896 mm)

The open top of the FXX K is not covered with vinyl, so the wrap stops where the convertible roof begins. If the top is made of fabric, the film edges are tucked under the seals around the top well. If the top is a folding hard top, each folding panel is wrapped on its own to keep the edges clean. The installer measures the roof opening before cutting to make sure the film does not interfere with the top mechanism.

Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

Film: about 46 ft (14 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 54 ft (16.5 m).

Roof, hood, chrome delete and PPF on an FXX K

For smaller jobs on an FXX K, a partial wrap covers the hood, mirror caps and rear deck while leaving the rest of the body painted. An FXX K chrome delete replaces bright window trim and badges with black film, which changes the look without a full color change wrap. Paint protection film (PPF) is clear film applied to the front end to guard against stone chips on track days.

  • Partial wrap: hood, mirror caps, rear deck.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film on the front end, also over a wrap.

Wrapping a Ferrari FXX K: body, cut-outs and film

The FXX K is a convertible with two doors, and its 192.8 in (4,896 mm) length means a full wrap has long, continuous panels. The open body has no fixed roof to film, so film on the rear deck and doors ends where the top begins. The body shape includes large rear haunches and a low nose, which need careful stretching and relief cuts. A wrap on this car therefore requires more skill than on a smaller coupe, but the panel count is not unusually high.

FXX K wrap ideas start with the front splitter, side skirts and rear diffuser, which are separate parts that benefit from cut-outs. Door handles, fuel filler and lights are removed or masked so the film lies flat around them. The convertible top is not wrapped, so the film ends cleanly where the fabric or folding panel begins. If the top is a folding hard top, its panels are wrapped as their own pieces.

Knowing how much vinyl to wrap an FXX K means checking which body style you have, because the catalog lists only one generation and one style. The convertible body is the only one offered, so film quantity does not change between model years. The estimate of about 46 ft (14 m) of 60-inch (1.52 m) cast film covers the whole exterior except the top. If you choose chrome or patterned film, plan for about 54 ft (16.5 m) instead.

Questions about wrapping a Ferrari FXX K

How much vinyl does it take to wrap a Ferrari FXX K?

A Ferrari FXX K needs about 46 ft (14 m) of 60-inch (1.52 m) cast film for a full wrap. If you use chrome or patterned film, the estimate is about 54 ft (16.5 m). These figures cover the convertible body but not the top, which is left unwrapped.

Is the top of an FXX K wrapped?

No, the top of an FXX K is not wrapped. A fabric top is left bare and the film ends where it begins, while a folding hard top is wrapped as separate panels if the owner wants it covered.

Can I wrap only the hood or the roof of an FXX K?

Yes, you can wrap only the hood or the roof of an FXX K, but the roof of a convertible is not wrapped. A partial wrap on this car normally includes the hood, mirror caps and rear deck rather than a roof panel. The rear deck is the closest panel to a roof on this open-top car.

Is an FXX K hard to wrap?

Yes, an FXX K is harder to wrap than an average car because its body is 192.8 in (4,896 mm) long and has many sharp edges. The convertible top must be masked off precisely so the film ends cleanly at the roof opening. Cut-outs around the front splitter, side skirts and rear diffuser also add time.