Wraps by car

Lancia Y10 wrap

The Lancia Y10 wrap calls for about 39 ft (12 m) of 60-inch (1.52 m) cast film for a full color change wrap. This page covers the single generation of the Lancia Y10, produced from 1985 to 1995. A vinyl wrap on the three-door hatchback body is a straightforward job with a few specific points to plan. Chrome or patterned film adds roughly 10 ft (3 m) to the total.

1generations12 mof film for a full wrap

Lancia Y10, first generation, factory photo
Lancia Y10, first generation. Factory color shown.

Lancia Y10 wrap colors and ideas

  • Lancia Y10 black wrap
  • Lancia Y10 white wrap
  • Lancia Y10 gray wrap
  • Lancia Y10 silver wrap
  • Lancia Y10 red wrap
  • Lancia Y10 blue wrap
  • Lancia Y10 green wrap
  • Lancia Y10 yellow wrap
  • Lancia Y10 orange wrap
  • Lancia Y10 purple wrap
  • Lancia Y10 pink wrap
  • Lancia Y10 teal wrap
  • Lancia Y10 brown wrap
  • Lancia Y10 gold wrap
  • Lancia Y10 chrome wrap
  • Lancia Y10 color shift wrap
  • Lancia Y10 carbon fiber wrap
  • Lancia Y10 camo and patterned wrap

How much vinyl to wrap a Lancia Y10

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1985–1995hatchback (3 doors)133.5 in (3,390 mm)about 39 ft (12 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 49 ft (15 m)

Lancia Y10 wrap cost factors

A Lancia Y10 wrap cost depends on the area of film and the condition of a car of these years. The full body needs about 39 ft (12 m) of 60-inch (1.52 m) film, but chrome or patterned film raises that to about 49 ft (15 m). More complex film or a two-tone design adds labor, as does careful prep on a 1985 to 1995 body. Removing old adhesive or repairing chips before the wrap changes the final bill.

  • Film for a full wrap: about 39 ft (12 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 49 ft (15 m).
  • Body: hatchback (3 doors).
  • A tailgate with the rear glass in it: the film ends at the edge of the glass.
  • Two long side doors: each door is one large piece of film.

Lancia Y10 wraps by generation

Swipe sideways. Tap a card for the full description.

Lancia Y10, first generation, factory photo
Factory color shown

1985–1995 Lancia Y10 hatchback (first generation)

1985–1995hatchback (3 doors)133.5 in (3,390 mm)

This page covers the first generation of the Lancia Y10, built from 1985 to 1995 with a three-door hatchback body. Paint age is a real factor on a car of these years, because panels may be original or repainted. A test spot on each panel comes before a full wrap to check how the film adheres. The wrap film will not fix rust or deep stone chips, so the body needs to be smooth first.

A tailgate with the rear glass in it: the film ends at the edge of the glass.

Two long side doors: each door is one large piece of film.

Film: about 39 ft (12 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 49 ft (15 m).

Roof, hood, chrome delete and PPF on a Lancia Y10

Smaller jobs on a Lancia Y10 include a partial wrap on the roof, hood, or mirror caps. A chrome delete covers the window trim and badges with black film. Paint protection film (PPF) can be applied as a clear film on the front end to guard against stone chips. These options use less film than a full wrap and still change the look or protect the paint.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film on the front end, also over a wrap.

Wrapping a Lancia Y10: body, cut-outs and film

A Lancia Y10 vinyl wrap is shaped by the car's compact hatchback body and its 133.5 in (3,390 mm) overall length. The three-door layout means only two long side doors, so each side of the car uses fewer separate pieces of film. A tailgate with the glass built into it means the film stops at the edge of the rear window. This simple outline keeps the number of panels low for a car of this age.

Lancia Y10 wrap ideas should start with the tailgate, where the film ends cleanly at the edge of the glass. The two long side doors are each covered with one large piece of film, which makes a smooth color change possible. Plan for cut-outs around the door handles, locks, and the badges on the rear. The mirror caps come off easily, which gives a neater result than wrapping around them.

If you are working out how much vinyl to wrap a Lancia Y10, remember that this page covers one generation built from 1985 to 1995. There is no earlier or later body to compare, so the film estimate does not change over the years. A full wrap of the hatchback takes about 39 ft (12 m) of 60-inch (1.52 m) cast film. Buy a little extra for the tailgate cut-out and for test pieces on old paint.

Questions about wrapping a Lancia Y10

How much vinyl does it take to wrap a Lancia Y10?

A full wrap of a Lancia Y10 takes about 39 ft (12 m) of 60-inch (1.52 m) cast film. If you choose chrome or patterned film, plan for about 49 ft (15 m). This is for the three-door hatchback body made from 1985 to 1995.

Can I wrap only the hood or the roof of a Lancia Y10?

Yes, you can wrap only the hood or the roof of a Lancia Y10 as a partial wrap. The roof is a good first project because it is a simple, flat panel. The hood is also a common partial wrap area and takes much less film than a full color change.

Is a Lancia Y10 hard to wrap?

A Lancia Y10 is not a hard car to wrap, but the tailgate with the glass in it adds work because the film must end at the edge of the glass. The two long side doors are each one large piece, which is easier than working around many small panels. Being a 1985 to 1995 car, the paint may need more prep before the film goes on.

How many generations of the Lancia Y10 does this page cover?

This page covers one generation of the Lancia Y10, produced from 1985 to 1995. It is the only generation of this model. All the film estimates and wrap details on this page refer to that single generation.