Wraps by car

Plymouth Superbird wrap

This page covers the Plymouth Superbird wrap for the one-generation sports car produced in 1970. A full vinyl wrap of the coupe body takes about 66 ft (20 m) of 60-inch (1.52 m) cast film. With chrome or patterned film the estimate is about 76 ft (23 m). The car is 217.7 in (5,530 mm) long.

1generations20 mof film for a full wrap

Plymouth Superbird, first generation, factory photo
Plymouth Superbird, first generation. Factory color shown.

Plymouth Superbird wrap colors and ideas

  • Superbird black wrap
  • Superbird white wrap
  • Superbird gray wrap
  • Superbird silver wrap
  • Superbird red wrap
  • Superbird blue wrap
  • Superbird green wrap
  • Superbird yellow wrap
  • Superbird orange wrap
  • Superbird purple wrap
  • Superbird pink wrap
  • Superbird teal wrap
  • Superbird brown wrap
  • Superbird gold wrap
  • Superbird chrome wrap
  • Superbird color shift wrap
  • Superbird carbon fiber wrap
  • Superbird camo and patterned wrap

How much vinyl to wrap a Plymouth Superbird

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1970–1970coupe (2 doors)217.7 in (5,530 mm)about 66 ft (20 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 76 ft (23 m)

Superbird wrap cost factors

Superbird wrap cost depends on the 217.7 in (5,530 mm) body length and the need to remove and reinstall the nose cone and rear wing. The choice of film changes the total area, from about 66 ft (20 m) of cast film to about 76 ft (23 m) with chrome or patterned film. Labor for the long doors and large panels also affects the final price.

  • Film for a full wrap: about 66 ft (20 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 76 ft (23 m).
  • Body: coupe (2 doors).
  • Two long side doors: each door is one large piece of film.

Superbird wraps by generation

Swipe sideways. Tap a card for the full description.

Plymouth Superbird, first generation, factory photo
Factory color shown

1970–1970 Superbird coupe (first generation)

1970–1970coupe (2 doors)217.7 in (5,530 mm)

The first generation Plymouth Superbird was built only in 1970 as a two-door coupe. Panels on a car of these years may be original or repainted, so a test spot comes before a full wrap. You need about 66 ft (20 m) of 60-inch (1.52 m) cast film for the body.

Two long side doors: each door is one large piece of film.

Film: about 66 ft (20 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 76 ft (23 m).

Roof, hood, chrome delete and PPF on a Superbird

Partial wrap on a Superbird can cover the roof, hood and mirror caps as separate pieces. A Superbird chrome delete changes the window trim and badges to black film. Paint protection film (PPF) puts clear film on the front end to stop stone chips.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Plymouth Superbird: body, cut-outs and film

A Plymouth Superbird vinyl wrap has to follow the coupe's long nose and tall rear wing. The two-door body is 217.7 in (5,530 mm) long, and its panels are large but simple in shape. You need about 66 ft (20 m) of 60-inch (1.52 m) film for the full body. Using chrome or patterned film raises the figure to about 76 ft (23 m).

Superbird wrap ideas start with removing the rear wing and front nose cone for clean film edges. The two long side doors each go on as one large piece of film. You also take off badges, mirrors and trim before the wrap goes on. Reinstalling the parts after the wrap gives a factory look.

Knowing how much vinyl to wrap a Superbird matters because only one generation exists, from 1970 to 1970. There are no earlier or later body styles to change the film estimate. The coupe shape stayed the same through that single production year. The film estimate of about 66 ft (20 m) applies to every Superbird.

Questions about wrapping a Plymouth Superbird

How much vinyl does it take to wrap a Plymouth Superbird?

Yes, a Plymouth Superbird needs about 66 ft (20 m) of 60-inch (1.52 m) cast film for a full wrap. With chrome or patterned film the estimate is about 76 ft (23 m).

Can I wrap only the hood or the roof of a Superbird?

Yes, you can wrap only the hood or the roof of a Superbird. These jobs are part of a partial wrap that also covers mirror caps. A chrome delete covers window trim and badges, and clear paint protection film (PPF) protects the front end.

Is a Superbird hard to wrap?

Yes, a Superbird is hard to wrap because of its 217.7 in (5,530 mm) length and the two long side doors that each need one large piece of film. The nose cone and rear wing also have to come off for clean edges.

How many generations of the Superbird does this page cover?

This page covers one generation of the Plymouth Superbird, produced from 1970 to 1970. The catalog lists only the first generation coupe with two doors.