Wraps by car

Pontiac Sunfire wrap

The Pontiac Sunfire wrap page covers the first generation, sold from 1995 to 2005, in convertible, coupe, and sedan bodies. A full vinyl wrap of the newest body takes about 48 ft (14.5 m) to 51 ft (15.5 m) of 60-inch film. The convertible is at the lower end, while the sedan uses the most material. These figures assume a standard color change wrap without extra chrome or patterned film.

1generations14.5 mof film for a full wrap

Pontiac Sunfire, first generation, factory photo
Pontiac Sunfire, first generation. Factory color shown.

Pontiac Sunfire wrap colors and ideas

  • Sunfire black wrap
  • Sunfire white wrap
  • Sunfire gray wrap
  • Sunfire silver wrap
  • Sunfire red wrap
  • Sunfire blue wrap
  • Sunfire green wrap
  • Sunfire yellow wrap
  • Sunfire orange wrap
  • Sunfire purple wrap
  • Sunfire pink wrap
  • Sunfire teal wrap
  • Sunfire brown wrap
  • Sunfire gold wrap
  • Sunfire chrome wrap
  • Sunfire color shift wrap
  • Sunfire carbon fiber wrap
  • Sunfire camo and patterned wrap

How much vinyl to wrap a Pontiac Sunfire

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1995–2005convertible, coupe, sedan (2 or 4 doors)181.7 in (4,615 mm) to 181.9 in (4,620 mm)about 48 ft (14.5 m) for the convertible to 51 ft (15.5 m) for the sedan, 60-inch (1.52 m) cast film; chrome or patterned film: up to about 64 ft (19.5 m)

Sunfire wrap cost factors

A Sunfire wrap cost depends on the size of the body, how much of the car is covered, and the film you pick. A sedan is the longest job, using up to about 51 ft (15.5 m) of 60-inch film, while a convertible takes about 48 ft (14.5 m). Partial wraps, chrome delete, or paint protection film (PPF) lower the amount of film and labor. The installer's time for removing mirrors, handles, and trim also changes the cost.

  • Film for a full wrap: about 48 ft (14.5 m) for the convertible to 51 ft (15.5 m) for the sedan, 60-inch (1.52 m) cast film; chrome or patterned film: up to about 64 ft (19.5 m).
  • Body: convertible, coupe, sedan (2 or 4 doors).
  • Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

Sunfire wraps by generation

Swipe sideways. Tap a card for the full description.

Pontiac Sunfire, first generation, factory photo
Factory color shown

1995–2005 Sunfire convertible, coupe, sedan (first generation)

1995–2005convertible, coupe, sedan (2 or 4 doors)181.7 in (4,615 mm) to 181.9 in (4,620 mm)

On the first generation Pontiac Sunfire, the open top of the convertible is not covered with vinyl. The wrap film ends where the fabric top begins, following the beltline around the rear window and side edges. If the convertible has a folding hard top, that top is wrapped as separate panels, with seams at the panel gaps. The installer masks off the fabric or seals the edges to protect it from adhesive.

Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

Film: about 48 ft (14.5 m) for the convertible to 51 ft (15.5 m) for the sedan, 60-inch (1.52 m) cast film; chrome or patterned film: up to about 64 ft (19.5 m).

Roof, hood, chrome delete and PPF on a Sunfire

A partial wrap on a Pontiac Sunfire covers the roof, the hood, or the mirror caps instead of the whole car. Sunfire chrome delete covers the window trim and badges with black film for a different look. Paint protection film (PPF) is a clear option that goes on the front end to guard against stone chips. These smaller jobs use less film and take less time than a full color change wrap.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Pontiac Sunfire: body, cut-outs and film

A Pontiac Sunfire vinyl wrap has to work around three body styles: a two-door convertible, a two-door coupe, and a sedan with two or four doors. The car is compact, with a length from 181.7 in (4,615 mm) to 181.9 in (4,620 mm), so fewer panels and less film are needed than for a larger sedan. The sedan has four door handles and longer rear doors, which adds a little material and labor. The coupe and convertible share similar front ends, so your choice mostly changes the roof and rear quarter area.

Sunfire wrap ideas often focus on the chrome trim, badges, and door handles, since these parts need cut-outs or are removed before wrapping. The third brake light, side mirrors, and antenna also require cut-outs for a clean finish. For a convertible, the fabric top is not wrapped, and the film ends where the top begins. A folding hard top, if present, is wrapped as panels of its own.

To figure out how much vinyl to wrap a Sunfire, check the body style and year, because the convertible, coupe, and sedan differ in film use. All first-generation cars from 1995 to 2005 have the same basic shape, so the difference is mainly roof and door area. The convertible needs about 48 ft (14.5 m) of 60-inch film, while the sedan needs about 51 ft (15.5 m). If you choose chrome or patterned film, you may need up to about 64 ft (19.5 m) to match patterns or cover extra trim.

Questions about wrapping a Pontiac Sunfire

How much vinyl does it take to wrap a Pontiac Sunfire?

A full wrap of a Pontiac Sunfire takes about 48 ft (14.5 m) to 51 ft (15.5 m) of 60-inch cast film. The convertible uses about 48 ft (14.5 m), and the sedan uses about 51 ft (15.5 m). If you want chrome or patterned film, plan for up to about 64 ft (19.5 m). These numbers are for the first-generation body sold from 1995 to 2005.

Is the top of a Sunfire wrapped?

No, the fabric top of a Sunfire convertible is not wrapped. The vinyl film ends where the top begins, around the beltline. A folding hard top, if the car has one, is wrapped as its own panels. This keeps the top's movement and seals working as they should.

Which Sunfire body takes more film?

The sedan takes more film than the convertible or coupe. A Sunfire sedan needs about 51 ft (15.5 m) of 60-inch film, while the convertible needs about 48 ft (14.5 m). The sedan has larger rear doors and a fixed roof that add surface area. The coupe falls between the two, closer to the convertible.

Can I wrap only the hood or the roof of a Sunfire?

Yes, you can wrap only the hood or the roof of a Sunfire. A partial wrap on the roof, hood, or mirror caps is a smaller job that still changes the look. For a more protective option, clear paint protection film (PPF) on the front end guards against stone chips. The installer will cut around the edges and remove any needed trim for a clean finish.