Wraps by car

Oldsmobile Intrigue wrap

The Oldsmobile Intrigue wrap page covers one generation of this full-size sedan, produced from 1997 to 2002. A full vinyl wrap of the newest body takes about 56 ft (17 m) of 60-inch (1.52 m) cast film. Chrome or patterned film adds about 69 ft (21 m) to the same job. The car is a four-door sedan with a length of 195.6 in (4,968 mm).

1generations17 mof film for a full wrap

Oldsmobile Intrigue, first generation, factory photo
Oldsmobile Intrigue, first generation. Factory color shown.

Oldsmobile Intrigue wrap colors and ideas

  • Intrigue black wrap
  • Intrigue white wrap
  • Intrigue gray wrap
  • Intrigue silver wrap
  • Intrigue red wrap
  • Intrigue blue wrap
  • Intrigue green wrap
  • Intrigue yellow wrap
  • Intrigue orange wrap
  • Intrigue purple wrap
  • Intrigue pink wrap
  • Intrigue teal wrap
  • Intrigue brown wrap
  • Intrigue gold wrap
  • Intrigue chrome wrap
  • Intrigue color shift wrap
  • Intrigue carbon fiber wrap
  • Intrigue camo and patterned wrap

How much vinyl to wrap an Oldsmobile Intrigue

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1997–2002sedan (4 doors)195.6 in (4,968 mm)about 56 ft (17 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m)

Intrigue wrap cost factors

Intrigue wrap cost depends on the film quality, the size of the car, and the labor to remove parts. The full wrap uses about 56 ft (17 m) of cast film, or about 69 ft (21 m) for chrome or patterned film. The length of 195.6 in (4,968 mm) drives the amount of material. The age of the paint on a 1997–2002 car also adds prep time, which affects the cost.

  • Film for a full wrap: about 56 ft (17 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m).
  • Body: sedan (4 doors).

Intrigue wraps by generation

Swipe sideways. Tap a card for the full description.

Oldsmobile Intrigue, first generation, factory photo
Factory color shown

1997–2002 Intrigue sedan (first generation)

1997–2002sedan (4 doors)195.6 in (4,968 mm)

The first generation Oldsmobile Intrigue runs from 1997 to 2002. Paint age on a car of these years can vary from original to repainted panels, so you do a test spot before a full wrap. A repainted panel may lift when you remove the film, so you check adhesion on each surface. This step protects the paint and the wrap warranty.

Film: about 56 ft (17 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m).

Roof, hood, chrome delete and PPF on an Intrigue

An Intrigue chrome delete covers the window trim and badges with black film. A partial wrap on this car can include the roof, hood, or mirror caps. Paint protection film (PPF) as a clear film on the front end shields the hood, bumper, and fenders. These jobs use less film than a full wrap and can be done in stages.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping an Oldsmobile Intrigue: body, cut-outs and film

The Oldsmobile Intrigue vinyl wrap uses one body style: a four-door sedan. Its length of 195.6 in (4,968 mm) and large roof, hood, and trunk panels make a full wrap a substantial job. The doors are tall and the bumpers are deep, so you plan seams along body lines rather than across flat areas. A wrap on this car covers more square footage than a compact sedan.

Intrigue wrap ideas start with the door handles, mirrors, and antenna base, which you remove or mask before laying film. Emblems and the trunk lock need cut-outs, and the side moldings can be wrapped or left as an accent. The roof rails are narrow, so you use knifeless tape for a clean line. You also remove the front and rear bumper covers for the best wrap on the lower valances.

To know how much vinyl to wrap an Intrigue, count one generation: 1997–2002. The sedan body size stays the same across all years, so the film estimate does not change. A car with a sunroof may need slightly less film on the roof panel. You order extra film for the bumpers if they have deep contours.

Questions about wrapping an Oldsmobile Intrigue

How much vinyl does it take to wrap an Oldsmobile Intrigue?

It takes about 56 ft (17 m) of 60-inch (1.52 m) cast film to wrap an Oldsmobile Intrigue. For chrome or patterned film, the estimate is about 69 ft (21 m). These figures are for the first generation sedan, the only body offered from 1997 to 2002.

Can I wrap only the hood or the roof of an Intrigue?

Yes, you can wrap only the hood or the roof of an Intrigue. A partial wrap on this car also covers mirror caps as a common option. The roof is large, so you need a helper to lay the film smoothly. A chrome delete with window trim and badges is another smaller job.

Is an Intrigue hard to wrap?

The Intrigue is a hard wrap because of its size and body lines. Its length of 195.6 in (4,968 mm) requires long pieces of film that you must manage without wrinkles. The bumpers have deep contours that need stretching and post-heating. You also remove door handles, mirrors, and the antenna base to get a clean install.

How many generations of the Intrigue does this page cover?

This page covers one generation of the Intrigue, produced from 1997 to 2002. There is no earlier or later generation in the catalog. The sole body style is a four-door sedan.