Wraps by car

Chrysler 300M wrap

The Chrysler 300M wrap page covers the first generation of the Chrysler 300M luxury sedan, produced from 1998 to 2004. This section covers that single generation only. A full vinyl wrap of the 300M body takes about 56 ft (17 m) of 60-inch (1.52 m) cast film.

1generations17 mof film for a full wrap

Chrysler 300M, first generation, factory photo
Chrysler 300M, first generation. Factory color shown.

Chrysler 300M wrap colors and ideas

  • Chrysler 300M black wrap
  • Chrysler 300M white wrap
  • Chrysler 300M gray wrap
  • Chrysler 300M silver wrap
  • Chrysler 300M red wrap
  • Chrysler 300M blue wrap
  • Chrysler 300M green wrap
  • Chrysler 300M yellow wrap
  • Chrysler 300M orange wrap
  • Chrysler 300M purple wrap
  • Chrysler 300M pink wrap
  • Chrysler 300M teal wrap
  • Chrysler 300M brown wrap
  • Chrysler 300M gold wrap
  • Chrysler 300M chrome wrap
  • Chrysler 300M color shift wrap
  • Chrysler 300M carbon fiber wrap
  • Chrysler 300M camo and patterned wrap

How much vinyl to wrap a Chrysler 300M

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1998–2004sedan (4 doors)196.9 in (5,000 mm)about 56 ft (17 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m)

Chrysler 300M wrap cost factors

The Chrysler 300M wrap cost depends on the size of the car, the number of panels and the film you choose. This sedan is 196.9 in (5,000 mm) long, so a full wrap takes about 56 ft (17 m) of film in a standard width. A chrome or patterned film needs about 69 ft (21 m) because the pattern must be matched. The cost also changes with the amount of disassembly and the condition of the paint.

  • Film for a full wrap: about 56 ft (17 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m).
  • Body: sedan (4 doors).

Chrysler 300M wraps by generation

Swipe sideways. Tap a card for the full description.

Chrysler 300M, first generation, factory photo
Factory color shown

1998–2004 Chrysler 300M sedan (first generation)

1998–2004sedan (4 doors)196.9 in (5,000 mm)

The first generation Chrysler 300M was built from 1998 to 2004, so the paint may be original or repainted on any given car. A test spot on a clean panel shows whether the film will stick without lifting old paint. Wrapping a car with aged or repainted panels takes more care and can add time. A professional shop will check the paint before quoting a full wrap.

Film: about 56 ft (17 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m).

Roof, hood, chrome delete and PPF on a Chrysler 300M

A Chrysler 300M chrome delete covers the window trim and badges with black film for a subtle look. A partial wrap can cover the roof, hood or mirror caps on their own without doing the whole car. Paint protection film (PPF) goes on the front end as a clear layer against stone chips.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film on the front end, also over a wrap.

Wrapping a Chrysler 300M: body, cut-outs and film

The Chrysler 300M vinyl wrap covers a four-door sedan that measures 196.9 in (5,000 mm) long. The large roof, long hood and tall doors mean each panel takes a wide sheet and a careful stretch. The body has no sharp body lines, but the deep front and rear bumpers need to be wrapped in smaller pieces.

Chrysler 300M wrap ideas should account for the door handles, mirror caps, antenna and badges. Those parts come off, get wrapped separately and go back on for a clean edge. The chrome window trim is best covered with a black film for a chrome delete look.

If you need to know how much vinyl to wrap a Chrysler 300M, the figure is the same for the whole first generation from 1998 to 2004. The sedan body was not changed in those years, so one film estimate fits every car. A full wrap uses about 56 ft (17 m) of 60-inch (1.52 m) cast film.

Questions about wrapping a Chrysler 300M

How much vinyl does it take to wrap a Chrysler 300M?

A Chrysler 300M takes about 56 ft (17 m) of 60-inch (1.52 m) cast film for a full wrap. That figure covers the first generation sedan from 1998 to 2004. A chrome or patterned film needs about 69 ft (21 m) because the pattern must be aligned.

Can I wrap only the hood or the roof of a Chrysler 300M?

Yes, you can wrap only the hood or the roof of a Chrysler 300M. A partial wrap on this car covers the roof, hood or mirror caps without doing the whole body. Those panels are large and flat, so they make a good first vinyl project.

Is a Chrysler 300M hard to wrap?

A Chrysler 300M is not hard to wrap, but the size and the trim add work. The car is 196.9 in (5,000 mm) long, so each side panel needs a long piece of film. The door handles, mirror caps, antenna and badges come off for a clean install, which takes extra time.

How many generations of the Chrysler 300M does this page cover?

This page covers one generation of the Chrysler 300M. The first generation was produced from 1998 to 2004 as a four-door sedan. There is no information on other generations in this guide.