Pacifica wrap cost depends on the body size, the film finish, and the number of cut-outs. A first-generation van is shorter at 198.9 in (5,052 mm) and uses less film than the second generation at 203.8 in (5,176 mm). Chrome or patterned film takes about 15 percent more material, and every trim has sensors, cameras, and lamps that need cut-outs. The roof height of 70.0 in (1,777 mm) on the newer van adds labor time for access.

2016–now Pacifica van (second generation)
The second-generation Pacifica has sliding side doors that shape the wrap on both sides. The door tracks stay bare because film in the track would peel and jam the door. The vinyl is cut along the track line, so the panels above and below are wrapped as separate pieces. This cut line is the same on every trim of this generation.
Sliding side doors: the door tracks stay bare, and the film is cut along them.
Some trims have a panoramic glass roof: glass is not wrapped, and the film ends at the roof rails.
Some trims have roof rails: they come off before the roof is wrapped, or the film is cut along them.
Every trim has parking sensors in the bumpers: the film is cut around each sensor.
Every trim has cameras in the body: the film is cut around each lens.
Every trim has fog lamps in the front bumper: cut-outs in the bumper film.
Plug-in and electric versions: the charge port door is wrapped as a small piece of its own.
A tall body (70.0 in (1,777 mm)): the roof is wrapped from a platform.
Film: about 77 ft (23.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 92 ft (28 m).
