Wraps by car

Chrysler Nassau wrap

This page covers a Chrysler Nassau wrap with one generation from 2007–2007 and a vinyl wrap taking about 66 ft (20 m) of 60-inch (1.52 m) cast film; chrome or patterned film takes about 74 ft (22.5 m). The Nassau is a full-size hatchback with five doors and a length of 196.1 in (4,981 mm). It shows the film amounts for the single body style. You can use these figures to plan material for the whole car.

1generations20 mof film for a full wrap

Chrysler Nassau, first generation, factory photo
Chrysler Nassau, first generation. Factory color shown.

Chrysler Nassau wrap colors and ideas

  • Nassau black wrap
  • Nassau white wrap
  • Nassau gray wrap
  • Nassau silver wrap
  • Nassau red wrap
  • Nassau blue wrap
  • Nassau green wrap
  • Nassau yellow wrap
  • Nassau orange wrap
  • Nassau purple wrap
  • Nassau pink wrap
  • Nassau teal wrap
  • Nassau brown wrap
  • Nassau gold wrap
  • Nassau chrome wrap
  • Nassau color shift wrap
  • Nassau carbon fiber wrap
  • Nassau camo and patterned wrap

How much vinyl to wrap a Chrysler Nassau

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
2007–2007hatchback (5 doors)196.1 in (4,981 mm)about 66 ft (20 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 74 ft (22.5 m)

Nassau wrap cost factors

Nassau wrap cost depends on the film type chosen, the size of the car at 196.1 in (4,981 mm), and the condition of the paint on a 2007 body. The amount of film needed is about 66 ft (20 m) for a standard color change, with more for chrome or patterned film. Labor is also a factor because the five-door hatchback has more edges and a tailgate with glass. Any paint correction before wrapping adds to the total work.

  • Film for a full wrap: about 66 ft (20 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 74 ft (22.5 m).
  • Body: hatchback (5 doors).
  • A tailgate with the rear glass in it: the film ends at the edge of the glass.

Nassau wraps by generation

Swipe sideways. Tap a card for the full description.

Chrysler Nassau, first generation, factory photo
Factory color shown

2007–2007 Nassau hatchback (first generation)

2007–2007hatchback (5 doors)196.1 in (4,981 mm)

The first generation Chrysler Nassau was made in 2007 as a full-size hatchback with five doors. For wrapping this generation, the panel sizes are fixed, so the film estimate of about 66 ft (20 m) applies to every 2007 Nassau. The paint age on a car of these years means panels may be original or repainted, and a test spot comes before a full wrap. The long body at 196.1 in (4,981 mm) calls for careful handling of the large roof and side pieces.

A tailgate with the rear glass in it: the film ends at the edge of the glass.

Film: about 66 ft (20 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 74 ft (22.5 m).

Roof, hood, chrome delete and PPF on a Nassau

A partial wrap on a Chrysler Nassau can cover the roof, hood, or mirror caps as separate jobs. Nassau chrome delete covers the window trim and badges with black film. Paint protection film (PPF) is a clear film applied to the front end to guard against stone damage. These smaller jobs use less material than a full wrap.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film on the front end, also over a wrap.

Wrapping a Chrysler Nassau: body, cut-outs and film

A Chrysler Nassau vinyl wrap covers one body style, a five-door hatchback with a length of 196.1 in (4,981 mm). The full-size body has large side panels and a long roof, which means the installer works with big pieces of film. The five doors add edges and handles that need careful trimming. A full wrap of this body uses about 66 ft (20 m) of 60-inch (1.52 m) cast film.

Nassau wrap ideas start with the tailgate, where the film ends at the edge of the rear glass because the glass is set into the tailgate. The front and rear bumpers need the film tucked around their contours. Door handles and side mirrors come off for a clean edge. The roof can be wrapped as a separate panel if a two-tone look is wanted.

To work out how much vinyl to wrap a Nassau, use the figure for the only body in the catalog: about 66 ft (20 m) of 60-inch (1.52 m) cast film. For chrome or patterned film, plan for about 74 ft (22.5 m) because the pattern must be matched at the seams. The extra film allows for waste on the large hatchback panels. A test spot on the paint is wise before a full wrap of a 2007 car.

Questions about wrapping a Chrysler Nassau

How much vinyl does it take to wrap a Chrysler Nassau?

A Chrysler Nassau takes about 66 ft (20 m) of 60-inch (1.52 m) cast film for a full wrap. If you use chrome or patterned film, the amount is about 74 ft (22.5 m). These figures are for the 2007 hatchback, the only body in the catalog.

Can I wrap only the hood or the roof of a Nassau?

Yes, you can wrap only the hood or the roof of a Nassau. Partial wrap jobs on this car include the roof, hood, and mirror caps. A chrome delete of the window trim and badges is another option. Paint protection film (PPF) on the front end is a clear partial wrap.

Is a Nassau hard to wrap?

A Nassau is not especially hard to wrap, but its size and tailgate add work. The body is 196.1 in (4,981 mm) long, so the side panels need large pieces of film. The tailgate has the rear glass built in, so the film must end at the edge of the glass. These details mean a careful install rather than a quick one.

How many generations of the Nassau does this page cover?

This page covers one generation of the Chrysler Nassau, the first generation from 2007. The catalog lists only the 2007 hatchback body. All wrapping figures on this page apply to that generation.