Wraps by car

Mitsubishi Eclipse wrap

The Mitsubishi Eclipse wrap covers all four generations of this sports coupe and convertible, from the 1989–1995 first generation to the 2005–2011 fourth generation. A full wrap of the newest body needs about 49 ft (15 m) of 60-inch cast film for the convertible and 51 ft (15.5 m) for the coupe. Chrome or patterned vinyl can raise the total to about 62 ft (19 m) on that body.

4generations15 mof film for a full wrap

Mitsubishi Eclipse, fourth generation, factory photo
Mitsubishi Eclipse, fourth generation. Factory color shown.

Mitsubishi Eclipse wrap colors and ideas

  • Eclipse black wrap
  • Eclipse white wrap
  • Eclipse gray wrap
  • Eclipse silver wrap
  • Eclipse red wrap
  • Eclipse blue wrap
  • Eclipse green wrap
  • Eclipse yellow wrap
  • Eclipse orange wrap
  • Eclipse purple wrap
  • Eclipse pink wrap
  • Eclipse teal wrap
  • Eclipse brown wrap
  • Eclipse gold wrap
  • Eclipse chrome wrap
  • Eclipse color shift wrap
  • Eclipse carbon fiber wrap
  • Eclipse camo and patterned wrap

How much vinyl to wrap a Mitsubishi Eclipse

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
2005–2011convertible, coupe (2 doors)179.7 in (4,565 mm) to 180.4 in (4,582 mm)about 49 ft (15 m) for the convertible to 51 ft (15.5 m) for the coupe, 60-inch (1.52 m) cast film; chrome or patterned film: up to about 62 ft (19 m)
2000–2006convertible, coupe (2 doors)175.4 in (4,455 mm)about 48 ft (14.5 m) for the convertible to 49 ft (15 m) for the coupe, 60-inch (1.52 m) cast film; chrome or patterned film: up to about 54 ft (16.5 m)
1997–1999coupe (2 doors)172.6 in (4,385 mm)about 48 ft (14.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 54 ft (16.5 m)
1989–1995coupe (2 doors)170.9 in (4,340 mm)about 46 ft (14 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 54 ft (16.5 m)

Eclipse wrap cost factors

Eclipse wrap cost depends on the film area, panel count, and any extra trim work. The fourth-generation coupe uses about 51 ft (15.5 m) of film and the convertible about 49 ft (15 m). Chrome delete or patterned film increases the material to about 62 ft (19 m) on the newest body, which adds labor and film work.

  • Film for a full wrap: about 49 ft (15 m) for the convertible to 51 ft (15.5 m) for the coupe, 60-inch (1.52 m) cast film; chrome or patterned film: up to about 62 ft (19 m).
  • Body: convertible, coupe (2 doors).
  • Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.
  • Two long side doors: each door is one large piece of film.
  • Restyled in 2008: bumpers and lights differ between the versions, and so do the film cuts.

Eclipse wraps by generation

Swipe sideways. Tap a card for the full description.

Mitsubishi Eclipse, fourth generation, factory photo
Factory color shown

2005–2011 Eclipse convertible, coupe (fourth generation)

2005–2011convertible, coupe (2 doors)179.7 in (4,565 mm) to 180.4 in (4,582 mm)

The fourth-generation Eclipse convertible has a fabric top that is not wrapped, and the film ends where the top begins. A folding hard top on some trims is wrapped as panels of its own. The coupe version of the 2005–2011 Eclipse uses the same door film pieces as the convertible.

Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

Two long side doors: each door is one large piece of film.

Film: about 49 ft (15 m) for the convertible to 51 ft (15.5 m) for the coupe, 60-inch (1.52 m) cast film; chrome or patterned film: up to about 62 ft (19 m).

Mitsubishi Eclipse, third generation, factory photo
Factory color shown

2000–2006 Eclipse convertible, coupe (third generation)

2000–2006convertible, coupe (2 doors)175.4 in (4,455 mm)

The third-generation Eclipse covers 2000–2006 models, but the years overlap with the fourth-generation body from 2005 to 2006. An owner of a car from those years checks which body it is before ordering film. The third generation was not restyled mid-cycle, so all 3G coupes and convertibles share one cut pattern.

Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

Two long side doors: each door is one large piece of film.

Film: about 48 ft (14.5 m) for the convertible to 49 ft (15 m) for the coupe, 60-inch (1.52 m) cast film; chrome or patterned film: up to about 54 ft (16.5 m).

Mitsubishi Eclipse, second generation, factory photo
Factory color shown

1997–1999 Eclipse coupe (second generation)

1997–1999coupe (2 doors)172.6 in (4,385 mm)

The second-generation Eclipse from 1997–1999 is over two decades old, so panels may be original or repainted. A test spot is applied before a full wrap to check paint adhesion. Paint protection film on this generation also requires careful surface preparation to avoid lifting at the edges.

Two long side doors: each door is one large piece of film.

Film: about 48 ft (14.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 54 ft (16.5 m).

Mitsubishi Eclipse, first generation, factory photo
Factory color shown

1989–1995 Eclipse coupe (first generation)

1989–1995coupe (2 doors)170.9 in (4,340 mm)

The first-generation Eclipse is the smallest, at 170.9 in (4,340 mm) long, and its compact two-door body takes about 46 ft (14 m) of 60-inch film. The two long side doors wrap as one piece each, so the total number of panels is lower than on later coupes. A simple paint finish on this body means less film waste at the cut edges.

Two long side doors: each door is one large piece of film.

Film: about 46 ft (14 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 54 ft (16.5 m).

Roof, hood, chrome delete and PPF on an Eclipse

Eclipse chrome delete and partial wrap jobs cover smaller areas than a full color change. A partial wrap can include the roof, hood, or mirror caps in a contrasting film. Chrome delete on the Eclipse covers the window trim and badges with black film. Paint protection film on the front end protects the bumper and hood with clear film.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Mitsubishi Eclipse: body, cut-outs and film

A Mitsubishi Eclipse vinyl wrap changes with each body style and size. The fourth-generation coupe is up to 180.4 in (4,582 mm) long, while the first-generation coupe is 170.9 in (4,340 mm). Convertibles add a fabric top that is not wrapped and reduce the film estimate by about 2 ft (0.5 m) compared to the coupe of the same generation.

Eclipse wrap ideas start with the two long side doors, which install as one large piece each and give the car a clean look. Convertible bodies need special attention where the film ends at the fabric top or the folding hard top panels. For color change wraps, the film is tucked under the roof seals to leave a crisp edge.

The amount of vinyl to wrap an Eclipse depends on the generation and body. A fourth-generation coupe needs about 51 ft (15.5 m) of 60-inch film, while a first-generation coupe takes about 46 ft (14 m). The 2008 restyle of the fourth generation does not change the film estimate but may alter the cut pattern slightly.

Questions about wrapping a Mitsubishi Eclipse

How much vinyl does it take to wrap a Mitsubishi Eclipse?

About 49 ft (15 m) of 60-inch cast film wraps a fourth-generation Eclipse convertible, and about 51 ft (15.5 m) wraps the coupe. Chrome or patterned film on the newest body can take up to about 62 ft (19 m). The first-generation coupe needs only about 46 ft (14 m).

Is the top of an Eclipse wrapped?

No, the fabric top of an Eclipse convertible is not wrapped. The film ends where the top begins on the body panels. A folding hard top on some fourth-generation convertibles is wrapped as its own panels.

Which years of the Eclipse take the same film cuts?

Each generation of the Eclipse takes different film cuts. The third generation covers 2000–2006 and the fourth covers 2005–2011, so 2005–2006 cars may be either body. The fourth generation was restyled in 2008, but the film cut pattern remains essentially the same.

Which Eclipse body takes more film?

The Eclipse coupe takes more film than the convertible of the same generation. In the fourth generation, the coupe uses about 51 ft (15.5 m) while the convertible uses about 49 ft (15 m). The difference is about 2 ft (0.5 m) because the fabric top is not wrapped.