Wraps by car

Mitsubishi eK Active wrap

The Mitsubishi eK Active wrap page covers this subcompact van, produced from 2004 to 2006 in a single generation. A full wrap of this body takes about 49 ft (15 m) of 60-inch (1.52 m) cast film. With chrome or patterned film, count about 57 ft (17.5 m). This guide lists the body details a wrap installer checks before cutting vinyl wrap.

1generations15 mof film for a full wrap

Mitsubishi eK Active, first generation, factory photo
Mitsubishi eK Active, first generation. Factory color shown.

Mitsubishi eK Active wrap colors and ideas

  • eK Active black wrap
  • eK Active white wrap
  • eK Active gray wrap
  • eK Active silver wrap
  • eK Active red wrap
  • eK Active blue wrap
  • eK Active green wrap
  • eK Active yellow wrap
  • eK Active orange wrap
  • eK Active purple wrap
  • eK Active pink wrap
  • eK Active teal wrap
  • eK Active brown wrap
  • eK Active gold wrap
  • eK Active chrome wrap
  • eK Active color shift wrap
  • eK Active carbon fiber wrap
  • eK Active camo and patterned wrap

How much vinyl to wrap a Mitsubishi eK Active

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
2004–2006van (5 doors)133.7 in (3,395 mm)about 49 ft (15 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 57 ft (17.5 m)

eK Active wrap cost factors

An eK Active wrap cost depends on the film volume, the door work and the condition of the paint. The car needs about 49 ft (15 m) of 60-inch (1.52 m) cast film, and film price rises with special finishes like chrome. The sliding doors add labor since the tracks stay bare and the film must be cut along them twice. Surface prep also changes the quote if the 2004-to-2006 paint needs more correction before the film goes on.

  • Film for a full wrap: about 49 ft (15 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 57 ft (17.5 m).
  • Body: van (5 doors).
  • Sliding side doors: the door tracks stay bare, and the film is cut along them.

eK Active wraps by generation

Swipe sideways. Tap a card for the full description.

Mitsubishi eK Active, first generation, factory photo
Factory color shown

2004–2006 eK Active van (first generation)

2004–2006van (5 doors)133.7 in (3,395 mm)

The first generation Mitsubishi eK Active was built from 2004 to 2006 and offered one van body with five doors. Its sliding side doors are the main wrap point: the tracks stay bare and decide where the film is cut. At 133.7 in (3,395 mm) long, this generation is small enough for a single installer to handle alone. The body code H81W identifies this generation on parts and film templates.

Sliding side doors: the door tracks stay bare, and the film is cut along them.

Film: about 49 ft (15 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 57 ft (17.5 m).

Roof, hood, chrome delete and PPF on an eK Active

An eK Active chrome delete covers the window trim and badges with black film for a simpler look. A partial wrap can be limited to the roof, hood or mirror caps when a full color change is not needed. Paint protection film (PPF) as a clear film on the front end shields the hood and bumper from stone chips. These smaller jobs use less material than the full wrap estimate of 49 ft (15 m).

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Mitsubishi eK Active: body, cut-outs and film

A Mitsubishi eK Active vinyl wrap is sized around its only body style, a five-door van that measures 133.7 in (3,395 mm) long. The tall, boxy shape keeps panel shapes simple, but the sliding side doors add cutting work around their tracks. The rear hatch and front doors are large flat areas, so film can go on in fewer pieces than on a curved coupe. Because the car is short, an installer can often use offcuts from a full roll for smaller panels.

For eK Active wrap ideas, start with the sliding side doors and the parts around them. The door tracks stay bare, and the film is cut along them so the doors still open cleanly. The door handles, mirrors, badges and rear wiper should be removed for a clean edge. The roof rails, if the car has them, are easier to wrap with the rails taken off first.

To work out how much vinyl to wrap an eK Active, you only need figures for its single generation, made from 2004 to 2006. Mitsubishi kept the same body length and door layout for the whole production run. The estimate of about 49 ft (15 m) of 60-inch (1.52 m) cast film therefore fits every eK Active of those years. If you choose chrome or patterned film, plan for about 57 ft (17.5 m) because pattern matching leaves more waste.

Questions about wrapping a Mitsubishi eK Active

How much vinyl does it take to wrap a Mitsubishi eK Active?

About 49 ft (15 m) of 60-inch (1.52 m) cast film is needed to wrap a Mitsubishi eK Active, based on its 2004-to-2006 van body. With chrome or patterned film the figure rises to about 57 ft (17.5 m) because pattern matching creates more waste. These numbers assume a full color change wrap on the single-generation body.

Are the sliding doors of an eK Active wrapped?

Yes, the panels of the sliding doors are wrapped, but the tracks stay bare. The film is cut along the tracks so the doors can still slide without catching the vinyl. This detail is specific to the eK Active and its 2004-to-2006 van body.

Can I wrap only the hood or the roof of an eK Active?

Yes, you can wrap only the hood or the roof of an eK Active. A partial wrap on this car often covers the roof, hood or mirror caps. Chrome delete is another small job that covers the window trim and badges instead of painting them.

Is an eK Active hard to wrap?

The Mitsubishi eK Active is not hard to wrap, but its sliding side doors add work. The door tracks stay bare, so the installer must cut and tuck the film along them on both sides. At 133.7 in (3,395 mm) long, the small body also means fewer seams and faster panel coverage.