Wraps by car

Mitsubishi Minica wrap

The Mitsubishi Minica wrap page covers all eight generations of this mini car, from 1977 to 2011. A full wrap of the newest body takes about 44 ft (13.5 m) of 60-inch (1.52 m) cast film. With chrome or patterned film, plan on about 52 ft (16 m).

8generations13.5 mof film for a full wrap

Mitsubishi Minica, eighth generation, factory photo
Mitsubishi Minica, eighth generation. Factory color shown.

Mitsubishi Minica wrap colors and ideas

  • Minica black wrap
  • Minica white wrap
  • Minica gray wrap
  • Minica silver wrap
  • Minica red wrap
  • Minica blue wrap
  • Minica green wrap
  • Minica yellow wrap
  • Minica orange wrap
  • Minica purple wrap
  • Minica pink wrap
  • Minica teal wrap
  • Minica brown wrap
  • Minica gold wrap
  • Minica chrome wrap
  • Minica color shift wrap
  • Minica carbon fiber wrap
  • Minica camo and patterned wrap

How much vinyl to wrap a Mitsubishi Minica

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1998–2011hatchback (3 or 5 doors)133.7 in (3,395 mm)about 44 ft (13.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 52 ft (16 m)
1993–1998hatchback (3 or 5 doors)129.7 in (3,295 mm)about 43 ft (13 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 51 ft (15.5 m)
1989–1993hatchback (3 doors)129.7 in (3,295 mm)about 38 ft (11.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 48 ft (14.5 m)
1984–1989hatchback (3 or 5 doors)125.8 in (3,195 mm)about 36 ft (11 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 48 ft (14.5 m)
1977–1984hatchback (3 doors)125.0 in (3,175 mm)about 34 ft (10.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 41 ft (12.5 m)
1974–1977hatchback (3 doors)——
1969–1974hatchback (3 doors)——
1961–1969hatchback (3 doors)——

Minica wrap cost factors

Minica wrap cost depends on the amount of film, the number of panels, and the prep work each generation needs. The eighth generation needs about 44 ft (13.5 m) of film, but a fourth generation needs only 34 ft (10.5 m). Doors and the tailgate on some generations require extra finishing time. Paint condition also changes the preparation work before the film goes on.

  • Film for a full wrap: about 44 ft (13.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 52 ft (16 m).
  • Body: hatchback (3 or 5 doors).
  • A tailgate with the rear glass in it: the film ends at the edge of the glass.

Minica wraps by generation

Swipe sideways. Tap a card for the full description.

Mitsubishi Minica, eighth generation, factory photo
Factory color shown

1998–2011 Minica hatchback (eighth generation)

1998–2011hatchback (3 or 5 doors)133.7 in (3,395 mm)

The eighth generation Mitsubishi Minica was produced from 1998 to 2011 as a hatchback with 3 or 5 doors. Paint age is a factor on a car from these years, as panels may be original or repainted. A test spot comes before a full wrap to check how the film bonds to the existing paint. This step helps avoid lifting on older finishes.

A tailgate with the rear glass in it: the film ends at the edge of the glass.

Film: about 44 ft (13.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 52 ft (16 m).

Mitsubishi Minica, seventh generation, factory photo
Factory color shown

1993–1998 Minica hatchback (seventh generation)

1993–1998hatchback (3 or 5 doors)129.7 in (3,295 mm)

The seventh generation Mitsubishi Minica was produced from 1993 to 1998 as a hatchback with 3 or 5 doors. Its 129.7 in (3,295 mm) length and compact body mean about 43 ft (13 m) of cast film for a full wrap. The number of panels is the same for 3-door and 5-door versions apart from the extra rear doors. With chrome or patterned film, plan on about 51 ft (15.5 m).

A tailgate with the rear glass in it: the film ends at the edge of the glass.

Film: about 43 ft (13 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 51 ft (15.5 m).

Mitsubishi Minica, sixth generation, factory photo
Factory color shown

1989–1993 Minica hatchback (sixth generation)

1989–1993hatchback (3 doors)129.7 in (3,295 mm)

The sixth generation Mitsubishi Minica was produced from 1989 to 1993 as a 3-door hatchback. Its 129.7 in (3,295 mm) length and simple body shape need about 38 ft (11.5 m) of cast film for a full wrap. Two long side doors are each one large piece of film, which reduces seams but increases the skill needed. Chrome or patterned film raises the estimate to about 48 ft (14.5 m).

A tailgate with the rear glass in it: the film ends at the edge of the glass.

Two long side doors: each door is one large piece of film.

Film: about 38 ft (11.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 48 ft (14.5 m).

Mitsubishi Minica, fifth generation, factory photo
Factory color shown

1984–1989 Minica hatchback (fifth generation)

1984–1989hatchback (3 or 5 doors)125.8 in (3,195 mm)

The fifth generation Mitsubishi Minica was produced from 1984 to 1989 as a hatchback with 3 or 5 doors. At 125.8 in (3,195 mm) long, it needs about 36 ft (11 m) of cast film for a full wrap. The 5-door version adds two rear door panels, but the overall film area stays close. Chrome or patterned film raises the estimate to about 48 ft (14.5 m).

A tailgate with the rear glass in it: the film ends at the edge of the glass.

Film: about 36 ft (11 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 48 ft (14.5 m).

Mitsubishi Minica, fourth generation, factory photo
Factory color shown

1977–1984 Minica hatchback (fourth generation)

1977–1984hatchback (3 doors)125.0 in (3,175 mm)

The fourth generation Mitsubishi Minica was produced from 1977 to 1984 as a 3-door hatchback. Its 125.0 in (3,175 mm) length and small panel count need about 34 ft (10.5 m) of cast film for a full wrap. Two long side doors are each one large piece of film, which demands careful installation. With chrome or patterned film, plan on about 41 ft (12.5 m).

A tailgate with the rear glass in it: the film ends at the edge of the glass.

Two long side doors: each door is one large piece of film.

Film: about 34 ft (10.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 41 ft (12.5 m).

Mitsubishi Minica, third generation, factory photo
Factory color shown

1974–1977 Minica hatchback (third generation)

1974–1977hatchback (3 doors)

A tailgate with the rear glass in it: the film ends at the edge of the glass.

Two long side doors: each door is one large piece of film.

Mitsubishi Minica, second generation, factory photo
Factory color shown

1969–1974 Minica hatchback (second generation)

1969–1974hatchback (3 doors)

A tailgate with the rear glass in it: the film ends at the edge of the glass.

Two long side doors: each door is one large piece of film.

Mitsubishi Minica, first generation, factory photo
Factory color shown

1961–1969 Minica hatchback (first generation)

1961–1969hatchback (3 doors)

A tailgate with the rear glass in it: the film ends at the edge of the glass.

Two long side doors: each door is one large piece of film.

Roof, hood, chrome delete and PPF on a Minica

A partial wrap on a Minica can cover the roof, hood, or mirror caps instead of the full body. Minica chrome delete covers the window trim and badges with black film for a darker look. Paint protection film, a clear film on the front end, guards against stone chips. These smaller jobs use less film and can be completed in less time than a full wrap.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Mitsubishi Minica: body, cut-outs and film

A Mitsubishi Minica vinyl wrap is shaped by the car's compact hatchback body and short overall length. The eighth generation is 133.7 in (3,395 mm) long and comes as a 3- or 5-door hatchback. The seventh and sixth generations are slightly shorter at 129.7 in (3,295 mm). Fewer body panels and a smaller roof reduce the film area compared to larger cars.

Minica wrap ideas have to work around the tailgate, which includes the rear glass. The film ends at the edge of the glass on every generation, so the hatch is split into several pieces. On the sixth and fourth generations, two long side doors mean each door is one large piece of film. These doors need careful handling to avoid stretching the film.

How much vinyl to wrap a Minica depends on the generation and body style. The newest eighth generation uses about 44 ft (13.5 m) of cast film, while the fourth generation uses only 34 ft (10.5 m). The fifth generation sits between them at about 36 ft (11 m). The third generation, sold only as a 3-door, needs about 38 ft (11.5 m).

Questions about wrapping a Mitsubishi Minica

How much vinyl does it take to wrap a Mitsubishi Minica?

How much vinyl does it take to wrap a Mitsubishi Minica? It takes about 44 ft (13.5 m) of 60-inch (1.52 m) cast film for the newest generation. That figure covers the full body of the eighth generation car. With chrome or patterned film, the amount rises to about 52 ft (16 m).

Can I wrap only the hood or the roof of a Minica?

Can I wrap only the hood or the roof of a Minica? Yes, a partial wrap can cover the roof, hood, or mirror caps. These smaller jobs let you change one area without wrapping the whole car. They use less film and are quicker to install than a full wrap.

Is a Minica hard to wrap?

Is a Minica hard to wrap? The tailgate with rear glass adds work on every generation, since the film must end at the edge of the glass. On the sixth and fourth generations, the two long side doors are each one large piece of film, which takes practice to handle without stretching. The car's small size reduces the total area, but the glass and door shapes still require care.

How many generations of the Minica does this page cover?

How many generations of the Minica does this page cover? This page covers eight generations of the Mitsubishi Minica, from 1977 to 2011. Each generation is listed with its body style and film estimate. The newest body is the eighth generation.