Wraps by car

Mitsubishi Pistachio wrap

The Mitsubishi Pistachio wrap guide covers the car in full, its one generation, and the vinyl wrap a full wrap of the newest body takes. The Pistachio is a mini hatchback produced from 1999 to 2000. A complete color change uses about 44 ft (13.5 m) of 60-inch (1.52 m) cast film. Chrome or patterned film takes about 52 ft (16 m) of the same width.

1generations13.5 mof film for a full wrap

Mitsubishi Pistachio, first generation, factory photo
Mitsubishi Pistachio, first generation. Factory color shown.

Mitsubishi Pistachio wrap colors and ideas

  • Pistachio black wrap
  • Pistachio white wrap
  • Pistachio gray wrap
  • Pistachio silver wrap
  • Pistachio red wrap
  • Pistachio blue wrap
  • Pistachio green wrap
  • Pistachio yellow wrap
  • Pistachio orange wrap
  • Pistachio purple wrap
  • Pistachio pink wrap
  • Pistachio teal wrap
  • Pistachio brown wrap
  • Pistachio gold wrap
  • Pistachio chrome wrap
  • Pistachio color shift wrap
  • Pistachio carbon fiber wrap
  • Pistachio camo and patterned wrap

How much vinyl to wrap a Mitsubishi Pistachio

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1999–2000hatchback (3 doors)135.4 in (3,440 mm)about 44 ft (13.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 52 ft (16 m)

Pistachio wrap cost factors

Pistachio wrap cost depends on the film type, the shop's labor, and the condition of the panels. The car is a single-generation mini hatchback with 135.4 in (3,440 mm) of body length. The tailgate with the glass set into it adds a step to the installation. The two long side doors are each one large piece, which affects the time spent.

  • Film for a full wrap: about 44 ft (13.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 52 ft (16 m).
  • Body: hatchback (3 doors).
  • A tailgate with the rear glass in it: the film ends at the edge of the glass.
  • Two long side doors: each door is one large piece of film.

Pistachio wraps by generation

Swipe sideways. Tap a card for the full description.

Mitsubishi Pistachio, first generation, factory photo
Factory color shown

1999–2000 Pistachio hatchback (first generation)

1999–2000hatchback (3 doors)135.4 in (3,440 mm)

The first generation Mitsubishi Pistachio was built from 1999 to 2000. On a car of these years panels may be original or repainted, and a test spot comes before a full wrap. Paint condition matters because the film adheres differently to aged or refinished surfaces. A small test area shows whether the film will bond evenly across each panel.

A tailgate with the rear glass in it: the film ends at the edge of the glass.

Two long side doors: each door is one large piece of film.

Film: about 44 ft (13.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 52 ft (16 m).

Roof, hood, chrome delete and PPF on a Pistachio

Partial wrap jobs on a Pistachio include the roof, hood, and mirror caps. Pistachio chrome delete covers the window trim and badges with black film. Paint protection film can be applied as clear film on the front end. These smaller jobs use less material than a full color change wrap.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Mitsubishi Pistachio: body, cut-outs and film

The Mitsubishi Pistachio vinyl wrap is shaped by its single three-door hatchback body and compact 135.4 in (3,440 mm) length. The small panels mean fewer large film pieces and less material than on bigger cars. The tailgate includes the rear glass, so the film stops at the edge of the glass. Each long side door is wrapped as one large piece of film.

Pistachio wrap ideas begin with the tailgate, where the rear glass is set into the panel. The film ends at the edge of the glass rather than wrapping around it. The two long side doors take one large piece of film each, which reduces visible seams. Installers remove or mask badges and trim before applying the film.

How much vinyl to wrap a Pistachio stays the same across the catalog because the car has only one generation. The 1999–2000 hatchback is the only body style listed for this model. Film estimators use the same dimensions for every Pistachio. A full wrap of the 135.4 in (3,440 mm) body takes the stated amounts.

Questions about wrapping a Mitsubishi Pistachio

How much vinyl does it take to wrap a Mitsubishi Pistachio?

A Mitsubishi Pistachio needs about 44 ft (13.5 m) of 60-inch (1.52 m) cast film for a full wrap. Chrome or patterned film takes about 52 ft (16 m) of the same width. The estimate is for the 1999–2000 hatchback body.

Can I wrap only the hood or the roof of a Pistachio?

Yes, you can wrap only the hood or the roof of a Pistachio. These partial jobs are listed in the partial wrap options for this car. Roof, hood, and mirror caps can be wrapped separately from the rest of the body.

Is a Pistachio hard to wrap?

A Pistachio is not especially hard to wrap, but the tailgate with the rear glass adds work. The film must end at the edge of the glass, so the installer trims that edge carefully. The two long side doors are each one large piece of film, which is straightforward. The car's compact size also reduces the total area to cover.

How many generations of the Pistachio does this page cover?

This page covers one generation of the Pistachio, the 1999–2000 hatchback. The catalog lists only that generation for this model. All wrap estimates and notes refer to that single body style.